Related papers: Morphology of PbTe crystal surface sputtered by ar…
A nanopowder from p-Bi-Sb-Te with particles ~ 10 nm were fabricated by the ball milling using different technological modes. Cold and hot pressing at different conditions and also SPS process were used for consolidation of the powder into a…
Spark plasma sintering (SPS) technique is applied in combination with hydrogen decrepitation process for the recycling of SmCo5 magnets. The SmCo5 magnets for recycling were first decrepitated by hydrogen gas of a pressure of 4 bar for 3…
We present temperature dependent frequency shift and line broadening of phonon modes by insertion of atomic layers of Pb and PbTe in the prototype 3D topological insulator Bi2Te3, using Raman spectroscopy. Good quality single crystals of…
Magnetic multilayers are a promising platform for storage and logic devices based on skyrmion spin textures, due to the large materials phase space for tuning properties. Epitaxial superlattice structures of [Pt/Co/Cu]n thin films were…
Bi2Te3 is a member of a new class of materials known as topological insulators which are supposed to be insulating in the bulk and conducting on the surface. However experimental verification of the surface states has been difficult in…
In this work fluctuations in the electric field of surface plasmon polaritons undergoing random scattering on a rough metallic surface are considered. A rigorous closed form analytic expression is derived describing second order…
The interference patterns of the surface plasmon polaritons(SPPs) on the metal surface from a "point" source are observed. These interference patterns come from the forward SPPs and the reflected one from the obstacles, such as…
Recent experimental studies focusing on the morphological properties of surfaces eroded by ion-bombardment report the observation of self-affine fractal surfaces, while others provide evidence about the development of a periodic ripple…
Information on the equation of state (EOS) of neutron matter may be gained from studies of 208Pb. Descriptions of 208Pb require credible models of structure, taking particular note also of the spectrum. Such may be tested by analyses of…
The topological properties of the bulk band structure of a three-dimensional topological insulator (TI) manifest themselves in the form of metallic surface states. In this paper, we propose a probe which directly couples to an exotic…
Ternary Ba-Fe-As system has been studied to determine a primary solidification field of the BaFe$_2$As$_2$ phase. We found that the BaFe$_2$As$_2$ phase most likely melts congruently and primarily solidifies either in the FeAs excess or…
Both theoretical and experimental analysis are carried out to understand the physical properties of the fascinating electronic and optical properties of antimony tungstate (Sb$_2$WO$_6$). The nanosized ($\sim 40-80~nm$) material is produced…
We grow epitaxial Sm-Co thin films by sputter deposition from an alloy target with a nominal SmCo5 composition on Cr(100)-buffered MgO(100) single-crystal substrates. By varying the Ar gas pressure, we can change the composition of the film…
Metallization of Schottky surface gates by sputtering Au on strained Si/SiGe heterojunctions enables the depletion of the two dimensional electron gas (2DEG) at a relatively small voltage while maintaining an extremely low level of leakage…
We present an angle-resolved photoemission spectroscopy study of the electronic structure of SnTe, and compare the experimental results to ab initio band structure calculations as well as a simplified tight-binding model of the p-bands. Our…
A new experimental equipment allowing to study the sputtering induced by ion beam irradiation is presented. The sputtered particles are collected on a catcher which is analyzed in situ by Auger electron spectroscopy without breaking the…
Normal incidence ion irradiation at elevated temperatures, when amorphization is prevented, induces novel nanoscale patterns of crystalline structures on elemental semiconductors by a reverse epitaxial growth mechanism: on Ge surfaces…
When a sculptured thin film (STF), made of a metal and $\leq50$ nm thick, is used in lieu of a dense layer of metal in the Kretschmann configuration, experimental data for an STF comprising parallel tilted nanowires shows that a surface…
Thin films of iron and permalloy Ni80Fe20 were prepared using an Ar+N2 mixture with magnetron sputtering technique at ambient temperature. The nitrogen partial pressure, during sputtering process was varied in the range of 0 to 100%,…
We propose a model accounting for plasmons within a two temperature description, to investigate the role of surface plasmon polaritons (SPP) in the energy redistribution between laser excited electrons and the lattice, leading to surface…