Related papers: Pile-up corrections in laser-driven pulsed x-ray s…
Certain radiation detectors are 'paralyzed' with high input count rates. When applied to count rates close to the event discriminator working rate the one-parameter dead time model fails. Here we present a corrected paralyzable detector…
Split-pulse x-ray photon correlation spectroscopy has been proposed as one of the unique capabilities made possible with the x-ray free electron lasers. It enables characterization of atomic scale structural dynamics that dictates the…
Stimulated Rayleigh scattering of pump and probe light pulses of close carrier frequencies is considered. A nonzero time delay between the two pulses is shown to give rise to amplification of the delayed (probe) pulse accompanied by…
X-ray emission spectroscopy is a well-established technique used to study continuum lowering in dense plasmas. It relies on accurate atomic physics models to robustly reproduce high-resolution emission spectra, and depends on our ability to…
Current sources of heralded single photons based on nonlinear optics operate in a probabilistic manner. In order to build quantum-enhanced devices based around the use of single photons, compact, turn-key and deterministic sources are…
A novel technique for divided-pulse amplification is presented in a proof-of-principle experiment. A pulse burst, cut out of the pulse train of a mode-locked oscillator, is amplified and temporally combined into a single pulse. High…
In recent years, ultrafast pump-probe spectroscopy has provided insightful information about nonequilibrium dynamics of excitations in materials. In a typical experiment of time-resolved x-ray absorption spectroscopy, the systems are…
The applicability of LaBr3:Ce detectors for high count rate {\gamma}-ray spectroscopy is investigated. A 3"x3" LaBr3:Ce detector is used in a test setup with radioactive sources to study the dependence of energy resolution and photo peak…
Triggered single-photon sources produce the vacuum state with non-negligible probability, but produce a much smaller multiphoton component. It is therefore reasonable to approximate the output of these photon sources as a mixture of the…
Refraction-enhanced x-ray radiography (REXR) is used to infer shock-wave positions of more than one shock wave, launched by a multiple-picket pulse in a planar plastic foil. This includes locating shock waves before the shocks merge, during…
It has been proposed by Cook (Phys. Scr. T 21, 49 (1988)) to use a short probe laser pulse for state measurements of two-level systems. In previous work we have investigated to what extent this proposal fulfills the projection postulate if…
Conventional x-ray imaging detectors suffer from parallax error when the radiation beam arrives at the detector surface at tilted angle. The image blurring occurs as the radiation penetrates detector material in lateral direction at tilted…
The prospects for accomplishing x-ray polarization measurements of astronomical sources have grown in recent years, after a hiatus of more than 37 years. Unfortunately, accompanying this long hiatus has been some confusion over the…
We consider the counting rate estimation of an unknown radioactive source, which emits photons at times modeled by an homogeneous Poisson process. A spectrometer converts the energy of incoming photons into electrical pulses, whose number…
Scattering of intense laser pulses on high-energy electron beams allows one to produce a large number of X and gamma rays. For temporally pulsed lasers the resulting spectra is broadband which severely limits practical applications. One…
We drastically improve the mode overlap between independently seeded, gain-switched laser diodes operating at gigahertz repetition rates by implementing a pulsed light seeding technique. Injecting pulsed light reduces the emission time…
The maturity of current detectors based on technologies that range from solid state to gases renewed the interest for X-ray polarimetry, raising the enthusiasm of a wide scientific community to improve the performance of polarimeters as…
In order to study photomultiplier's short-term gain stability at high counting rate, we constructed an LED pulsed light source and its output monitor system. For the monitor system, we employed a photon counting method using a…
Time-resolved studies have so far relied on rapidly triggering a photo-induced dynamic in chemical or biological ions or molecules and subsequently probing them with a beam of fast moving photons or electrons that crosses the studied…
We propose a method to remove the contributions of pileup events from higher-order cumulants and moments of event-by-event particle distributions. Assuming that the pileup events are given by the superposition of two independent…