Related papers: Petroleum Refinery Multi-Antenna Propagation Measu…
Wireless communication in millimeter wave spectrum is poised to provide the latency and bandwidth needed for advanced use cases unfeasible at lower frequencies. Despite the market potential of vehicular communication networks,…
Industry 4.0 relies heavily on wireless technologies. Energy efficiency and device cost have played a significant role in the initial design of such wireless systems for industry automation. However, high reliability, high throughput, and…
This letter provides a comparison of indoor radio propagation measurements and corresponding channel statistics at 28, 73, and 140 GHz, based on extensive measurements from 2014-2020 in an indoor office environment. Side-by-side comparisons…
A new method of antenna radiation pattern reconstruction using Chebyshev polynomials was presented in this paper. The analysis starts from the data measured in the frequency domain, and it corresponds to a direct propagating between two…
The emerging 5G and future 6G technologies are envisioned to provide higher bandwidths and coverage using millimeter wave (mmWave) and sub-Terahertz (THz) frequency bands. The growing demand for higher data rates using these bands can be…
TeraHertz (THz) communications are envisioned as a promising technology, owing to its unprecedented multi-GHz bandwidth. In this paper, wideband channel measurement campaigns at 140 GHz and 220 GHz are conducted in indoor scenarios…
We report the measurement of sub-Doppler double-resonance transitions in methane using a 3.3 $\mu$m continuous wave optical parametric oscillator to pump transitions in the fundamental $\nu_3$ band and a 1.67 $\mu$m frequency comb to probe…
In this paper, we conduct wireless channel measurements in indoor corridor scenarios at 2.4, 5 and 6 GHz bands with bandwidth of 320 MHz. The measurement results of channel characteristics at different frequency bands such as average power…
This letter investigates a fluid antenna system (FAS) where multiple ports can be activated for signal combining for enhanced receiver performance. Given $M$ ports at the FAS, the best $K$ ports out of the $M$ available ports are selected…
Path gain and effective directional gain in azimuth in urban canyons from actual rooftop base station sites are characterized based on a massive data set of 3000 links on 12 streets in two cities, with over 21 million individual continuous…
Channel uncertainty and co-channel interference are two major challenges in the design of wireless systems such as future generation cellular networks. This paper studies receiver design for a wireless channel model with both time-varying…
Two novel detection strategies for nonlinear Fourier transform-based transmission schemes are proposed. We show, through numerical simulations, that both strategies achieve a good performance improvement (up to 3 dB and 5 dB) with respect…
Since 2003, significant efforts have been devoted to the understanding of the radio emission of extensive air showers above 20 MHz. Despite some studies led until the early nineties, the band available below 20 MHz has remained unused for…
In this paper, the effects of interference on composite fading environments, where multipath fading coexists with shadowing, are investigated. Based on some mathematical convenient expressions for the sum of squared…
This paper presents 28 GHz and 73 GHz millimeter- wave propagation measurements performed in a typical office environment using a 400 Megachip-per-second broadband sliding correlator channel sounder and highly directional steerable 15 dBi…
The point-to-point multiple-antenna channel is investigated in uncorrelated block fading environment with Rayleigh distribution. The maximum throughput and maximum expected-rate of this channel are derived under the assumption that the…
We today live in the era of dynamic and mobile wireless enabled platforms. This kind of stringent communication capability in the face of volatile and turbulent mobility demands a fresh look at physical layer in general and antenna design…
This paper proposes a functionally reconfigurable integrated structure of a Fabry-Perot (FP) antenna and wideband liquid absorber. The partial reflecting surface (PRS) is elaborately tailored to serve as both a component of the FP antenna…
This work presents an experimental study of Single Input Multiple Output (SIMO) channel performance in indoor radio propagation environment. Indoor channel measurements at 2.4 GHz ISM frequency band have been performed using a versatile…
Millimeter-wave (mmWave) frequency bands are expected to be used for future 5G networks due to the availability of large unused spectrum. However, the attenuation at mmWave frequencies is high. To resolve this issue, the utilization of high…