Related papers: Petroleum Refinery Multi-Antenna Propagation Measu…
Large deployable antennas with a mesh surface woven by fine metal wires are an important technology for communications satellites and space radio telescopes. However, it is difficult to make metal mesh surfaces with sufficient…
The paper presents a reflectionless stripline filter with reduced dimensions having a single bandwidth over a wide frequency range. The filter consists of coupled strip lines and RLC circuits included in the diagonal ports of the coupled…
The THz band (0.1-10 THz) has attracted considerable attention for next-generation wireless communications, due to the large amount of available bandwidth that may be key to meet the rapidly increasing data rate requirements. Before…
Channel sounding is a vital step in understanding wireless channels for the design and deployment of wireless communication systems. In this paper, we present the design and implementation of a coherent distributed massive MIMO channel…
We present a measurement of phonon propagation in a silicon wafer utilizing an array of frequency-multiplexed superconducting resonators coupled to a single transmission line. The electronic readout permits fully synchronous array sampling…
Slant-polarized Multi Input Multi Output (MIMO) antennas are able to improve the performance of mobile communication systems in terms of channel capacity. Especially, the implementation of MIMO configurations for automotive applications…
Terahertz-band (100 GHz-10 THz) communication is a promising radio technology envisioned to enable ultra-high data rate, reliable and low-latency wireless connectivity in next-generation wireless systems. However, the low transmission power…
The introduction of 5G New Radio networks with massive MIMO technology has complicated electromagnetic field exposure assessments for radiation protection. Massive MIMO transmission enables beamforming, beam steering, and spatial…
We have analyzed observations from a radioastronomical experiment to survey the sky at decimetric wavelengths along with feed pattern measurements in order to account for the level of ground contamination entering the sidelobes. A major…
An active dipole antenna has been designed to measure transient electric field induced by ultra high energy cosmic rays for the CODALEMA experiment. The main requirements for this detector, composed of a low noise preamplifier placed close…
Since decades ago, multi-antenna has become a key enabling technology in the evolution of wireless communication systems. In contrast to conventional multi-antenna systems that contain antennas at fixed positions, position-flexible antenna…
In this article, a general information-plus-noise transmission model is assumed, the receiver end of which is composed of a large number of sensors and is unaware of the noise pattern. For this model, and under reasonable assumptions, a set…
This paper presents the design and performance analysis of a 1x6 linear microstrip patch antenna array tailored for automotive radar and 5G millimetre-wave (mm-wave) applications. The proposed antenna array comprises six rectangular…
In a companion paper we presented the theory for an antenna pattern measuring technique that uses (rather than mitigates) the properties of a multipath environment. Here we use measurements in a typical home garage to experimentally…
In any wireless communication network and system an antenna is an important element along the propagation path of an electrical signals. Antenna module is a vital component of automated driving systems, it should function as needed in dGPS,…
When signals propagate through forest areas, they will be affected by environmental factors such as vegetation. Different types of environments have different influences on signal attenuation. This paper analyzes the existing classical…
The evolution of large aperture antennas and arrays at the sub-THz band (100-300 GHz) results in traditional far-field (FF) gain measurements to require large distances due to the high frequency nature making them impractical in many…
The design of an improved microstrip antenna operating in the 28 GHz frequency spectrum is the main goal of this work. The design used a Roger RT 5880 LZ substrate with a thickness and permittivity of 0.762mm and 1.96, respectively. The…
Over the past few decades, attempts had been made to build a suitable channel prediction model to optimize radio transmission systems. It is particularly essential to predict the path loss due to the blockage of the signal, in indoor radio…
In this renovating era of technology, human life has considerably changed like transport has been transformed from bull cart to aircraft, land line phones to 4G/5G cellular phones, CRT based T. V to LED T. V etc. Human being has perceived…