Related papers: Calibration setup for ultralow-current transresist…
Using memristive properties common for the titanium dioxide thin film devices, we designed a simple write algorithm to tune device conductance at a specific bias point to 1% relative accuracy (which is roughly equivalent to 7-bit precision)…
Mixers play a crucial role in superconducting quantum computing, primarily by facilitating frequency conversion of signals to enable precise control and readout of quantum states. However, imperfections, particularly carrier leakage and…
This paper presents a joint calibration scheme for voltage (V) and current (I) probes that helps resolve accurately voltage-current phase differences even when the difference is very close to $90^{\circ}$. The latter has been a major issue…
An amplifier has been designed for optimal use of position sensitive thermal neutron detectors using the principle of resistive charge division. The important points in this optimization are: high counting rates and good spatial resolution.…
This paper investigates calibration of sensor arrays in the radio astronomy context. Current and future radio telescopes require computationally efficient algorithms to overcome the new technical challenges as large collecting area, wide…
Superconducting qubits are a leading platform for scalable quantum computing and quantum error correction. One feature of this platform is the ability to perform projective measurements orders of magnitude more quickly than qubit…
Reverberation chambers are currently used to test electromagnetic compatibility as well as to characterize antenna efficiency, wireless devices, and MIMO systems. The related measurements are based on statistical averages and their…
Calibration, the practice of choosing the parameters of a structural model to match certain empirical moments, can be viewed as minimum distance estimation. Existing standard error formulas for such estimators require a consistent estimate…
Radio interferometer arrays with non-homogeneous element patterns are more difficult to calibrate compared to the more common homogeneous array. In particular, the non-homogeneity of the patterns has significant implications on the…
Calibration refers to the estimation of unknown parameters which are present in computer experiments but not available in physical experiments. An accurate estimation of these parameters is important because it provides a scientific…
A method to precisely calibrate the oscillation amplitude in Dynamic Scanning Force Microscopy is described. It is experimentally shown that a typical electronics used to process the dynamic motion of the cantilever can be adjusted to…
The neutrino mass experiment KATRIN requires a stability of 3 ppm for the retarding potential at -18.6 kV of the main spectrometer. To monitor the stability, two custom-made ultra-precise high-voltage dividers were developed and built in…
The Transient Fluctuation Theorem is used to calibrate an Atomic Force Microscope by measuring the fluctuations of the work performed by a time dependent force applied between a collo{\"i}dal probe and the surface. From this measure one can…
A new method for absolute polarimetric calibration of large telescopes is presented. The proposed method is highly accurate and is based on the calibration of a small sub-aperture, which is then extended to the full system by means of…
In typical machine learning systems, an estimate of the probability of the prediction is used to assess the system's confidence in the prediction. This confidence measure is usually uncalibrated; i.e.\ the system's confidence in the…
In-circuit impedance measurement provides useful information for many EMC applications. The inductive coupling approach is a promising in-circuit impedance measurement method due to its non-contact characteristics and simple on-site…
A probabilistic model is said to be calibrated if its predicted probabilities match the corresponding empirical frequencies. Calibration is important for uncertainty quantification and decision making in safety-critical applications. While…
The Self-Excited Loop (SEL) architecture, used in some continuous-wave (CW) superconducting linacs, relies on a positive feedback mechanism that requires carefully defined operating limits to ensure stable operation. These limits are…
There is a need for techniques for efficient and accurate measurement of the impedance of rechargeable batteries at extra-low frequencies (ELFs, typically below 10uHz), as these reflect real usage and cycling patterns, and their importance…
Calibration is a key step in the signal processing pipeline of any radio astronomical instrument. The required sky, ionospheric and instrumental models for this step can suffer from various kinds of incompleteness. In this paper we analyze…