Related papers: Continuous-wave Raman Lasing in Aluminum Nitride M…
Inelastic light (Raman) scattering has been used to study electronic excitations and phonon anomalies in detwinned, slightly overdoped YBa$_2$Cu$_3$O$_{6.95}$ and moderately overdoped Y$_{0.85}$Ca$_{0.15}$Ba$_2$Cu$_3$O$_{6.95}$ single…
Generation of laser-like narrow bandwidth emissions from nitrogen molecular ions generated in intense near- and mid-infrared femtosecond laser fields has aroused much interest because of the mysterious physics underlying such a phenomenon…
A planar force-constant model is developed for longitudinal phonons of wurtzite GaN and AlN propagating along the [0001] direction. The proposed model is then applied to the study of the phonon modes in hexagonal GaN/AlN superlattices in…
The novel combination of a strongly-resonant optical metasurface with the MoS$_2$/WSe$_2$ hetero-bilayer is proposed for efficient free-space lasing enabled by the enhanced coupling between the optical and matter (exciton) states. The…
Advancing electromechanical resonators towards terahertz frequencies opens vast bandwidths for phononic signal processing. In quantum phononics, mechanical resonators at these frequencies can remain in their quantum ground state even at…
The scattering of lattice excitations (phonons) with the photoexcited charge carriers is of a major concern in optoelectronic devices. Here, the resonant Raman scattering will be utilized to study an exciton-phonon interaction in GaN…
The potential of silicon nanowires (SiNWs), (diameter < 10 nm) to transform into rigid bundle-like structures with distinct phonon confinement under high pressure (<= 15 GPa), instead of amorphising as per previous reports, is demonstrated…
A laser was designed and constructed with the goal of producing ultra-short pulses at a high repetition rate as needed for certain applications of multi-photon microscopy. With pure prism-based dispersion compensation repetition rates of up…
This work reports on the modeling, fabrication, and experimental characterization of a 13 GHz 30% Scandium-doped Aluminum Nitride (ScAlN) Overmoded Bulk Acoustic Resonator (OBAR) for high-frequency Radio Frequency (RF) applications, notably…
In this work, we have successfully engineered and examined suspended laterally vibrating resonators (LVRs) on a lithium niobate thin film on lithium niobate carrier wafer (LN-on-LN) platform, powered by aluminum interdigital transducers…
New, fundamental resonant properties of laser resonators are theoretically predicted and experimentally demonstrated. These resonances occur either in the time dependence of the beam width and that of beam radius of curvature of the…
This work reports on the measured performance of an Aluminum Scandium Nitride (AlScN) Two-Dimensional Resonant Rods resonator (2DRR), fabricated by using a Sc-doping concentration of 24%, characterized by a low off-resonance impedance (~25…
We report on the lattice and spin dynamics in the monopnictide CrAs using polarized Raman scattering. This system exhibits a first-order magneto-structural phase transition at T_N~ 265 K, below which the magnetic moments of Cr form an…
Ternary compounds obtained by alloying wurtzite AlN with transition metals have emerged as promising materials with significantly enhanced piezoelectric characteristics relative to binary AlN. The increased electromechanical coupling in…
We measure momentum-resolved Raman spectra of a spin-polarized degenerate Fermi gas of $^{173}$Yb atoms for a wide range of magnetic fields, where the atoms are irradiated by a pair of counterpropagating Raman laser beams as in the…
Aluminum and their alloys, after careful treatments, can develop excellent mechanical, tribological, electrical and chemical (high corrosion resistance) properties. However, 7000 series, with Cu in the alloy, have a poor corrosion…
We study band alignment in wurtzite-zincblende polytype InAs heterostructured nanowires using temperature dependent resonance Raman measurements. Nanowires having two different wurtzite fractions are investigated. Using visible excitation…
It has been long accepted that the second-order Raman bands in carbon nanotubes are enhanced through the double-resonance mechanism. Although separate aspects of this mechanism have been studied for a few second-order Raman bands, including…
This work describes sputtered scandium aluminum nitride (ScAlN) thin-film bulk acoustic resonators (FBAR) at 12.5 GHz with high electromechanical coupling (k2) of 9.5% and quality factor (Q) of 208, resulting in a figure of merit (FoM, Qk2)…
We study the second-order Raman process of mono- and few-layer MoTe$_2$, by combining {\em ab initio} density functional perturbation calculations with experimental Raman spectroscopy using 532, 633 and 785 nm excitation lasers. The…