Related papers: Room-temperature formation of Pt$_3$Si/Pt$_2$Si fi…
In this work, we studied the pathways for formation of stoichiometric \tcn~thin films. Polycrystalline and epitaxial \tcn~films were prepared using reactive direct current magnetron (dcMS) sputtering technique. A systematic variation in the…
We have investigated the structural and magnetic properties of BiFeO$_3$ (BFO) thin films grown over (100)-oriented Si substrates by rf magnetron sputtering in a new route under O$_2$ free low pressure Ar atmosphere. Single-phase BFO films…
Manganese silicide (MnxSiy) thin films with Mn content (CMn) varied from 24 at. % to 52 at. % were grown on i-GaAs (100) substrates. Chemical, phase composition and room temperature magnetic properties of the films were investigated. It was…
We report on an XPS study of AlN thin films grown on Si(100) substrates by ion beam sputter deposition (IBSD) in reactive assistance of N+/N2+ ions to unravel the compositional variation of their surface when deposited at different…
Thin films of Co2MnSi have been grown on a-plane sapphire substrates from three elemental targets by dc magnetron co-sputtering. These films are single phase, have a strong (110) texture and a saturation magnetization of 4.95 uB/formula…
The atomic structure and composition of non-interfacial ITO and ITO-Si interfaces were studied with Transmission Electron Microscopy (TEM) and X-ray Photoelectron Spectroscopy (XPS). The films were deposited by DC magnetron sputtering on…
We characterize composition and structure of ultrathin nickel silicide during formation from 3 nm Ni films on Si(100) using in-situ high resolution ion scattering and high resolution transmission electron microscopy. We show the transition…
We present a study of the thickness dependence of magnetism and electrical conductivity in ultra thin La0.67Sr0.33MnO3 films grown on SrTiO3 (110) substrates. We found a critical thickness of 10 unit cells below which the conductivity of…
Superconducting thin films with high intrinsic kinetic inductance $L_{k}$ are important for high-sensitivity detectors, enabling strong coupling in hybrid quantum systems, and enhancing nonlinearities in quantum devices. We report the…
Ferromagnetism above room temperature was observed in Cr-doped hydrogenated amorphous silicon films deposited by rf magnetron-sputtering. Structure analysis reveals that films are amorphous without any detectable precipitates up to the…
High-dielectric-constant CaCu3Ti4O12 (CCTO) thin films were prepared on Pt/Ti/SiO2/Si(100) substrates by pulsed-laser deposition. The 480 nm thick polycrystalline films have preferred orientation and show obvious crystallization on the…
In this work, amorphous thin films in Mg-Si-O-N system were prepared in order to investigate the dependence of optical and mechanical properties on Mg composition. Reactive RF magnetron co-sputtering from magnesium and silicon targets were…
Superconducting Nb3Sn films can be synthesized by controlling the atomic concentration of Sn. Multilayer sequential sputtering of Nb and Sn thin films followed by high temperature annealing is considered as a method to fabricate Nb3Sn…
Vanadium silicide (V$_3$Si) is a promising superconductor for integration with silicon-based electronics, however the interfacial growth kinetics have a strong influence on the resulting superconducting properties and are not yet fully…
Barium titanate, BaTiO3 (BT), materials have been synthesized by two different routes: one ball-mill-derived (BMD) nanopowder and another precursor-derived (PCD) BT synthesis method were used separately to fabricate BT thin films on…
The Bi1-xSbx was the first 3D topological insulator found in nature. It presents a complex electronic structure with topological to trivial transition and a semimetallic to semiconductor transition, both achieved by changing the x fraction…
Understanding the Gilbert damping in exchange-coupled multilayer materials is particularly important to develop future fast switching spintronics devices. Here, we report an experimental investigation of temperature-dependent Gilbert…
Ferroelectric BaTiO3 films with large polarization have been integrated with Si(001) by pulsed laser deposition. High quality c-oriented epitaxial films are obtained in a substrate temperature range of about 300 deg C wide. The deposition…
W-B-C films were deposited on Si(100) substrates held at elevated temperature by reactive sputtering from a W target in Kr/trimethylboron (TMB) plasmas. Quantitative analysis by X-ray photoelectron spectroscopy (XPS) shows that the films…
Specific heat of polycrystalline BaTiO3 thin films on the fused quartz substrate was measured by ac-hot probe method. Phase transition temperature, excess entropy and spontaneous polarization were determined as a function of film thickness…