Related papers: Transient phases during fast crystallization of or…
The molecule 2-decyl-7-phenyl[1]benzothieno[3,2-b][1]benzothiophene has gained a lot of attention, since high charge carrier mobility was observed in thin film transistors. Its thermotropic liquid crystalline states may play an important…
We study by scanning thermal microscopy the nanoscale thermal conductance of films (40 to 400 nm thick) of [1]benzothieno[3,2-b][1]benzothiophene (BTBT) and 2,7-dioctyl[1]benzothieno[3,2-b][1]benzothiophene (C8-BTBT-C8). We demonstrate that…
Superconducting NbTiN thin films have garnered extensive interest due to their use in Superconducting Nanowire Single-Photon Detectors (SNSPDs) and other low-temperature applications for potential use in quantum computing and…
The nucleation mechanisms during solution deposition of organic semiconductor thin films determine the grain morphology and may influence the crystalline packing in some cases. Here, in-situ optical spectromicroscopy in reflection mode is…
Barium titanate, BaTiO3 (BT), materials have been synthesized by two different routes: one ball-mill-derived (BMD) nanopowder and another precursor-derived (PCD) BT synthesis method were used separately to fabricate BT thin films on…
Thin films of the recently discovered magnesium diboride (MgB2) intermetalic superconducting compound have been grown using a magnetron sputtering deposition technique followed by in-situ annealing at 830 C. High quality films were obtained…
We report the growth of high-quality c-axis-oriented epitaxial MgB2 thin films by using a pulsed laser deposition technique. The thin films grown on (1`1 0 2) Al2O3 substrates show a Tc of 39 K. The critical current density in zero field is…
A transient surface instability is reported in thin nematic films of 5CB and 8CB, occurring near the nematic-isotropic phase transition. Although this instability leads to patterns reminiscent of spinodal dewetting, we show that it is…
An attempt has been made to synthesize (Ca0.4Sr0.6)Bi4Ti4O15(CSBT) thin film using pulsed laser deposition (PLD) and successfully optimized the deposition conditions. A good quality film with the desired phase is obtained at a substrate…
The fabrication, characterisation, and superconductivity of MgB2 thick films grown on stainless steel substrate were studied. XRD, SEM, and magnetic measurements were carried out. It was found that the MgB2 thick films can be fast formed by…
We find that the hole mobility of the crystal smectic phases of the liquid crystal 1,4-di-(5-n-tridecylthien-2-yl)-benzene increases exponentially with decreasing temperature. While qualitatively consistent with transport via polaron bands,…
The wetting behavior of thin films of 4'-n-octyl-4-cyanobiphenyl (8CB) on Si is investigated via optical and x-ray reflectivity measurement. An experimental phase diagram is obtained showing a broad thick-thin coexistence region spanning…
We have performed charge transfer phase formation studies on the donor/acceptor system bis(ethylendithio)tetrathiafulvalene,(BEDT-TTF)/tetracyanoquinodimethane,(TCNQ) by means of physical vapor deposition. We prepared donor/acceptor bilayer…
Organic molecules embedded in an organic matrix exhibit lifetime-limited optical coherence and bright emission at cryogenic temperatures below 3 K. Here we present a simple vapor-phase growth method for synthesizing optically thin DBT-doped…
Superconducting MgB2 thin films were prepared on Al2O3(0001) and MgO(100) substrates. Boron thin films were deposited by the electron-beam evaporation followed by post-annealing process with magnesium. Proper post annealing conditions were…
Highly textured chalcogenide films have recently gained significant interest for phase-change memory applications. Several reports have highlighted that programming efficiency improves in devices featuring superlattice stacks, such as…
We investigate transition to the superconducting state in the ultrathin titanium nitride films on approach to superconductor-insulator transition. Building on the complete account of quantum contributions to conductivity, we demonstrate…
The thermal deposition and transfer Printing method had been used to produce pentacene thin-films on SiO2/Si and plastic substrates (PMMA and PVP), respectively. X-ray diffraction patterns of pentacene thin films showed reflections…
MgB2 thin films were deposited on SiC buffered Si substrates by sequential electron beam evaporation of B-Mg bilayer followed by in-situ annealing. The application of a SiC buffer layer enables the maximum annealing temperature of 830 C.…
Ga2O3 thin films were deposited by reactive magnetron sputtering from a liquid gallium target. The influence of deposition temperature, substrate type, and discharge parameters on the structural and electrical properties was systematically…