Related papers: A Multi-Gigahertz Analog Transient Recorder Integr…
- This paper describes a pipeline analog-to-digital converter is implemented for high speed camera. In the pipeline ADC design, prime factor is designing operational amplifier with high gain so ADC have been high speed. The other advantage…
Microelectromechanical (MEMS) resonators are widely used in timekeeping applications, and recent advances in fabrication, materials, and encapsulation technology have advanced their potential as high stability frequency references. However,…
A decision feedback circuit with integrated offset compensation is presented in this paper. The circuit is built around the sense amplifier comparator. The feedback loop is closed around the first stage of the comparator resulting in…
Aims: We describe a 6-12 GHz analogue correlator that has been developed for use in radio interferometers. Methods: We use a lag-correlator technique to synthesis eight complex spectral channels. Two schemes were considered for sampling the…
A photonic integrated circuit comprised of an 11 cm multimode speckle waveguide, a 1x32 splitter, and a linear grating coupler array is fabricated and utilized to receive 2 GHz of RF signal bandwidth from 2.5 to 4.5 GHz using a 35 MHz mode…
Time-tagging units and coincidence detectors are used in many scientific research fields. The required timing resolution and number of input channels are varying, but some emerging experiments in the field of quantum optics require up to 32…
Nanoscale transistors require aggressive reduction of all channel dimensions: length, width, and thickness. While monolayer two-dimensional semiconductors (2DS) offer ultimate thickness scaling, good performance has largely been achieved…
An all-digital comparator with full input range is presented. It outperforms the nowaday all-digital comparators with its large rail-to-rail input range. This is achieved by the proposed Yin-yang balance mechanism between the two logic…
This paper describes a highly integrated, low power chip solution for ECG signal processing in wearable devices. The chip contains an instrumentation amplifier with programmable gain, a band-pass filter, a 12-bit SAR ADC, a novel QRS…
Time-of-flight measurement is an important advancement in PET scanners to improve image reconstruction with a lower delivered radiation dose. This article describes the monolithic ASIC for the TT-PET project, a novel idea for a…
This paper presents the design and characterization of a monolithic integrated circuit (IC) including digital silicon photomultipliers (dSiPMs) arranged in a 32$~\times~$32 pixel matrix at 70$~\mu$m pitch. The IC provides per-quadrant time…
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…
This paper describes the design and testing results of an 8 channels preamplifier-discriminator circuit based on a resistive feedback Transimpedance Amplifier architecture and a Leading-Edge Discriminator stage for fast high-accuracy time…
A 20 GHz LLRF system is being built using a two-board(RF Front End + ADC/DAC/FPGA) architecture. The RF Front End provides 8 down-converting channels and 3 up-converting channels (5.5-20 GHz RF to 0.05-3 GHz IF). Separate, phase locked,…
A 3.8ps root mean square (RMS) time synchronization implemented in a 20nm fabrication process ultrascale kintex Field Programmable Gate Array (FPGA) is presented. The multichannel high-speed serial transceivers (e.g. GTH) play a key role in…
Electronic systems are becoming more and more ubiquitous as our world digitises. Simultaneously, even basic components are experiencing a wave of improvements with new transistors, memristors, voltage/current references, data converters,…
A low-cost, stand-alone Global-Positioning-System-time-synchronized data acquisition system is described. The constructed prototype allows recoding up to four analog signals with a 16-bit resolution in variable ranges and a maximum sampling…
Few-layer phosphorene MOSFETs with 0.3-um-long gate and 15-nm-thick Al2O3 gate insulator was found to exhibit a forward-current cutoff frequency of 2 GHz and a maximum oscillation frequency of 8 GHz after de-embedding for the parasitic…
Emerging applications such as wireless sensing, position location, robotics, and many more are driven by the ultra-wide bandwidths available at millimeter-wave (mmWave) and Terahertz (THz) frequencies. The characterization and efficient…
A simple electronic circuit is described using four common and very inexpensive analog multiplexer/demultiplexer chips. These analog switches are used to select eight different wiring configurations to a van der Pauw sample. Several…