Related papers: A $55 Shock Tube for Simulated Blast Waves
The use of observed wearable sensor data (e.g., photoplethysmograms [PPG]) to infer health measures (e.g., glucose level or blood pressure) is a very active area of research. Such technology can have a significant impact on health…
We report here an experimental setup to perform three-pulse pump-probe measurements over a wide wavelength and temperature range. By combining two pump pulses in the visible (650-900 nm) and mid-IR (5-20 $\mu$m) range, with a broadband…
Plasma densification through magnetic compression has been suggested for time-resolved control of the wave properties in plasma-based accelerators. Using particle in cell simulations with real mass ratio, the practicality of large magnetic…
Soft multi-axis force/torque sensors provide safe and precise force interaction. Capturing the complete degree-of-freedom of force is imperative for accurate force measurement with six-axis force/torque sensors. However, cross-axis coupling…
To find a viable alternative to SF6 with growing climate change regulations, proper evaluation of alternatives such as compressed air ought to be done. For medium voltage applications, the withstand voltage is used as the dimensioning…
This study demonstrates the feasibility of using smaller capillary emitters to achieve higher specific impulse ($I_\text{sp}$) in electrospray propulsion. Four ionic liquids were characterized using capillary emitters with tip diameters…
Compressible vortex rings, usually formed at the open end of a shock tube, often show interesting phenomena during their formation, evolution, and propagation depending on the shock Mach number (Ms) and exit flow conditions. The Mach number…
We have built a variable temperature scanning probe microscope (SPM) that covers 4.6 K - 180 K and up to 7 Tesla whose SPM head fits in a 52 mm bore magnet. It features a temperature-controlled sample stage thermally well isolated from the…
Lightweight, single-use explosion containment structures provide an effective solution for neutralizing rogue explosives, combining affordability with ease of transport. This paper introduces a three-stage simulation framework that captures…
For the development of charged particle detectors based on straw tubes operating in vacuum, a special measurement technique is required for the evaluation of their mechanical properties. A summary of the known equations that govern straw…
Aerobreakup of fluid droplets under the influence of impulsively generated high-speed gas flow using an open-ended shock tube is studied using experiments and numerical simulations. Breakup of mm-sized droplets at high Weber number was…
Two-phase flow with low liquid loads is common in high-pressure natural gas offshore gathering and transmission pipelines. During gas production slowdowns or shutdowns, an accumulation of liquid in the lower sections of subsea pipelines may…
We present a soft corrugated tube sensor designed to estimate strain in each half segment. When air flows through the tube, the internal corrugated cavities induce pressure oscillations that excite the tube's standing wave resonance mode,…
As an alternative inertial confinement fusion scheme with predicted high energy gain and more robust designs, shock ignition requires a strong converging shock driven by a shaped pulse with a high-intensity spike at the end to ignite a…
Cardiopulmonary resuscitation (CPR) is one of the essential tools to ensure oxygen supply during cardiac arrest. However, the precise effects of chest compression are not quantifiable to this day. This often results in a low quality of…
Gas pressure sensors based on nanomechanical membranes have recently demonstrated an ultra-wide ten-decade measurement range, a gas-type-independent response, and a self-calibrating operation with uncertainties of approximately $1\,\%$. The…
Positive streamers in ambient air at pressures from 0.013 to 1 bar are investigated experimentally. The voltage applied to the anode needle ranges from 5 to 45 kV, the discharge gap from 1 to 16 cm. Using a "slow" voltage rise time of 100…
Bolometric experiments searching for rare events usually require an extremely low radioactive background to prevent spurious signals from mimicking those of interest, spoiling the sensitivity of the apparatus. In such contexts, radioactive…
Motivated by an experimental finding on the density of supercooled water at high pressure [O. Mishima, J. Chem. Phys. 133, 144503 (2010)] we performed atomistic molecular dynamics simulations study of bulk water in the isothermal-isobaric…
Initial test results of an L-band multi-beam klystron with parameters relevant for ILC are presented. The chief distinction of this tube from MBKs already developed for ILC is its low operating voltage of 60 kV, a virtue that implies…