Related papers: Intermodulation electrostatic force microscopy for…
A method for the separation and quantitative characterization of the electrostatic and Van der Waals contribution to tip-sample interaction in non-contact Scanning Force Microscopy is presented. It is based on the simultaneous measurement…
Josephson traveling wave parametric amplifiers enable the amplification of weak microwave signals close to the quantum limit with large bandwidth, which has a broad range of applications in superconducting quantum computing and in the…
We construct a low-temperature microwave waveguide interferometer for measuring high-frequency properties of two-dimensional electron gases (2DEGs). Coupled plasmon-cyclotron resonance (PCR) spectra are used to extract effective mass, bulk…
A mechanical electroscope based on a change in the resonant frequency of a cantilever one micron in size in the presence of charge has recently been fabricated. We derive the decoherence rate of a charge superposition during measurement…
Outlined here is a technique for sub-wavelength infrared surface imaging performed using a phase matched optical parametric oscillator laser and an atomic force microscope as the detection mechanism. The technique uses a novel surface…
Opto-mechano-fluidic resonators (OMFRs) are a new platform for high-throughput sensing of the mechanical properties of freely flowing microparticles in arbitrary media. Experimental extraction of OMFR mode shapes, especially the acoustic…
A mesoscopic device in the simple tunnel junction or quantum point contact geometry emits microwaves with remarkable quantum properties, when subjected to a sinusoidal drive in the GHz range. In particular, single and two-photon squeezing…
We present a theoretical framework for the dynamic calibration of the higher eigenmode parameters (stiffness and optical lever responsivity) of a cantilever. The method is based on the tip-surface force reconstruction technique and does not…
The soft character of organic materials leads to strong coupling between molecular nuclear and electronic dynamics. This coupling opens the way to control charge transport in organic electronic devices by inducing molecular vibrational…
We propose and demonstrate a spatial partition method for the high-frequency photo-response of superconducting devices correlated with inductive and resistive changes in microwave impedance. Using a laser scanning microscope, we show that…
Measurements of the deflection induced by thermal noise have been performed on a rectangular atomic force microscope cantilever in air. The detection method, based on polarization interferometry, can achieve a resolution of 1E-14 m/rtHz in…
Atomic-resolution imaging on molten metal/solid interfaces at temperatures above 200 {\deg}C was achieved using a high-temperature, high-speed atomic force microscope (AFM) equipped with a qPlus sensor. A tip-scanning high-speed Quadpod…
A single-passage, bimodal magnetic force microscopy technique optimized for scanning samples with arbitrary topography is discussed. A double phase-locked loop (PLL) system is used to mechanically excite a high quality factor cantilever…
Atomic force microscopy (AFM) is widely used to measure surface topography of solid, soft, and living matter at the nanoscale. Moreover, by mapping forces as a function of distance to the surface, AFM can provide a wealth of information…
A simple strobe setup with potential to study higher-order eigenmodes and multifrequency oscillations in micromechanical resonators is described. It requires standard equipment, commonly found in many laboratories, and it can thus be…
Nonlinear energy exchange between vibrational modes underlies phenomena ranging from internal resonance to wave mixing, yet modal interactions are typically inferred from frequency-domain signatures rather than directly observed in space.…
Microwaves generated by optical techniques have demonstrated unprecedentedly low noise and hold significance in various applications such as communication, radar, instrumentation, and metrology. To date, the purest microwave signals are…
We present polynomial force reconstruction from experimental intermodulation atomic force microscopy (ImAFM) data. We study the tip-surface force during a slow surface approach and compare the results with amplitude-dependence force…
All-optical modulation yields the promise of high-speed information processing. In this frame, metasurfaces are rapidly gaining traction as ultrathin multifunctional platforms for light management. Among the featured functionalities, they…
Dynamic interactions between two oscillating micromechanical cantilevers are studied. In the experiment, the tip of a high-frequency cantilever is positioned near the surface of a second low-frequency cantilever. Due to the highly nonlinear…