Related papers: Low Power Dual Edge-Triggered Static D Flip-Flop
A metallic ring based, diode-integrated, low-profile, power-dependent, reflective metasurface working from 3 GHz to 3.6 GHz is proposed in this letter. Unlike the previous study which shifts a band up and down to change the impedance of the…
Density functional theory (DFT) is a widespread and effective tool in electronic structure calculations for ground-state electron systems. Its success has prompted exploration into the use of DFT for non-collective excited states. The delta…
Electricity load forecasting enables the grid operators to optimally implement the smart grid's most essential features such as demand response and energy efficiency. Electricity demand profiles can vary drastically from one region to…
We propose and analyze a novel dual-gate Spin Field Effect Transistor (SpinFET) with half-metallic ferromagnetic source and drain contacts. The transistor has two gate pads that can be biased independently. It can be switched ON or OFF with…
We propose a dual-mode (DM) time domain multiplexed (TDM) chirp spread spectrum (CSS) modulation for spectral and energy-efficient low-power wide-area networks (LPWANs). DM-CSS modulation that uses both the even and odd cyclic time shifts…
As a result of improvements in power semiconductors, moderate frequency switching supplies can now provide the hundreds of amps typically required by accelerators with zero-to-peak noise in the kHz region ~0.06% in current or voltage mode.…
The increasing adoption of Deep Neural Network (DNN)-based Digital Pre-distortion (DPD) in modern communication systems necessitates efficient hardware implementations. This paper presents DPD-NeuralEngine, an ultra-fast, tiny-area, and…
Recent advances in distribution-level phasor measurement unit (D-PMU) technology have enabled the use of voltage phase angle measurements for direct load sharing control in distribution-level microgrid interconnections with high penetration…
Comparators have multifarious applications in various fields, especially used in analog to digital converters. Over the years, we have seen many different designs of single stage, dynamic latch type and double tail type comparators based on…
Energy harvesting is an attractive way to power future IoT devices since it can eliminate the need for battery or power cables. However, harvested energy is intrinsically unstable. While FPGAs have been widely adopted in various embedded…
The quality of energy produced in renewable energy systems has to be at the high level specified by respective standards and directives. The estimation accuracy of grid signal parameters is one of the most important factors affecting this…
The performance of pixel modules built from 75 micrometer thin silicon sensors and ATLAS read-out chips employing the Solid Liquid InterDiffusion (SLID) interconnection technology is presented. This technology, developed by the Fraunhofer…
In most digital-to-time converter (DTC) based applications, apart from maintaining low integral non-linearity (INL), it is also required of the system to achieve a wide frequency translation range. To achieve this performance, we present a…
A 6bit flash-ADC with 1.2GSps, wide analog bandwidth and low power, realized in a standard digital 0.13 $\mu$m CMOS copper technology is presented. Employing capacitive interpolation gives various advantages when designing for low power: no…
Low power design has become one of the most significant requirements when CMOS technology entered the nanometer era. Therefore, timing budget is often performed to slow down as many components as possible so that timing slacks can be…
Dynamic time-division duplex (D-TDD) has emerged as an effective solution to accommodate the unaligned downlink and uplink traffic in small cell networks. However, the flexibility of traffic configuration also introduces additional…
A family of interleaved current-fed high step-up dc-dc converters are introduced and analyzed here by combining a voltage multiplier (VM) and an active clamp circuit for high-voltage high-power applications. Low input currents and output…
We present a formulation of spin-conserving and spin-flip, hybrid time-dependent density functional theory (TDDFT), including the calculation of analytical forces, which allows for efficient calculations of excited state properties of…
As the demand for high-performance microprocessors increases, the circuit complexity and the rate of data transfer increases resulting in higher power consumption. We propose a clocking architecture that uses a series LC resonance and…
Microstrip three-way (that is, 4.8 dB) integrated filtering power divider (FPD) is presented in this paper. The proposed FPD evenly distributes an input power signal into three equal output signals. The design incorporates balanced signal…