Related papers: Low Power Dual Edge-Triggered Static D Flip-Flop

Using a set of oscillator strengths and excited-state dipole moments of near full configuration interaction (FCI) quality determined for small compounds, we benchmark the performances of several single-reference wave function methods (CC2,…

This paper presents a low-jitter hybrid voltage level shifter (HVLS) suitable for high-speed applications. The proposed architecture offers the advantage of cross-coupled feedback to simultaneously generate two voltage domain signals with…

Dissipative cat-qubits are a promising architecture for quantum processors due to their built-in quantum error correction. By leveraging two-photon stabilization, they achieve an exponentially suppressed bit-flip error rate as the distance…

5G-Advanced and likely 6G will support a new low-power wake-up signal (LP-WUS) enabling low-power devices, equipped with a complementary ultra low-power receiver to monitor wireless traffic, to completely switch off their main radio. This…

Almost all time-dependent density-functional theory (TDDFT) calculations of excited states make use of the adiabatic approximation, which implies a frequency-independent exchange-correlation kernel that limits applications to…

Real-time control of distribution networks requires accurate information about the system state. In practice, however, such information is difficult to obtain because real-time measurements are available only at a limited number of…

Near-degenerate electronic structures remain a major challenge for conventional single-reference density functional theory (DFT). To address this problem, we propose time-dependent $\Delta$SCF (TD$\Delta$SCF), a novel linear-response scheme…

This paper presents the novel Droop-e grid-forming inverter control strategy, which establishes an active power-frequency relationship based on an exponential function of the inverter power dispatch. The advantages of this control strategy…

In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on…

Latch-based designs have many benefits over their flip-flop based counterparts but have limited use partially because most RTL specifications are flop-centric and automatic conversion of FF to latch-based designs is challenging.…

This letter proposes a general decentralized control of cascaded inverters-power factor angle droop control. Compared to the existing control strategies, it has the following attractive benefits: 1) it is suitable for both grid-connected…

Power flow analysis plays a fundamental and critical role in the energy management system (EMS). It is required to well accommodate large and complex power system. To achieve a high performance and accurate power flow analysis, a graph…

In this chapter we focus on slack reclamation and propose a new slack reclamation technique, Multiple Frequency Selection DVFS (MFS-DVFS). The key idea is to execute each task with a linear combination of more than one frequency such that…

Edge devices are being deployed at increasing volumes to sense and act on information from the physical world. The discrete Fourier transform (DFT) is often necessary to make this sensed data suitable for further processing -- such as by…

The phase-locked loop (PLL) used in the doubly fed induction generator (DFIG) can cause frequency coupling phenomena, which will give negative resistance characteristics ofthe DFIG at low frequency, resulting in stability issues under weak…

It is well known that conventional Field Effect Transistors (FET's) require a change in the channel potential of at least 60 mV at 300K to effect a change in the current by a factor of ten, and this minimum subthreshold slope S puts a lower…

With the high demand of the portable electronic products, Low- power design of VLSI circuits & Power dissipation has been recognized as a challenging technology in the recent years. PLA (Programming logic array) is one of the important off…

Intensity-modulation and direct-detection (IM/DD) transmission is widely adopted for high-speed optical transmission scenarios due to its cost-effectiveness and simplicity. However, as the data rate increases, the fiber chromatic dispersion…

We develop DeepOPF as a Deep Neural Network (DNN) approach for solving security-constrained direct current optimal power flow (SC-DCOPF) problems, which are critical for reliable and cost-effective power system operation.DeepOPF is inspired…

Two-Dimensional (2D) Discrete Fourier Transform (DFT) is a basic and computationally intensive algorithm, with a vast variety of applications. 2D images are, in general, non-periodic, but are assumed to be periodic while calculating their…