Related papers: Efficient Transmit Beamspace Design for Search-fre…
This paper studies the coordinated beamforming design problem for the multiple-input single-output (MISO) interference channel, assuming only channel distribution information (CDI) at the transmitters. Under a given requirement on the rate…
Direction-of-arrival (DOA) estimation for incoherently distributed (ID) sources is essential in multipath wireless communication scenarios, yet it remains challenging due to the combined effects of angular spread and gain-phase…
We propose a design strategy for optimizing antenna positions in linear arrays for far-field Direction of Arrival (DoA) estimation of narrow-band sources in collocated MIMO radar. Our methodology allows to consider any spatial constraints…
The near-field effect of short-range multiple-input multiple-output (MIMO) systems imposes many challenges on direction-of-arrival (DoA) estimation. Most conventional scenarios assume that the far-field planar wavefronts hold. In this…
Reconfigurable antenna technology, such as movable antennas (MAs) and rotatable antennas (RAs), has emerged as a promising solution to enhance the communication performance of wireless systems by exploiting the new degree of freedom (DoF)…
We investigate the beampattern design problem for mono-static multi-user (MU) multi-point-target integrated sensing and communication (ISAC) systems, where a dual-function multiple-input multiple-output (DF-MIMO) base station (BS) performs…
The problem of direction of arrival (DOA) estimation has been studied for decades as an essential technology in enabling radar, wireless communications, and array signal processing related applications. In this paper, the DOA estimation…
This paper presents a general technique for the joint Direction-of-Arrival (DoA) and Time-of-Arrival (ToA) estimation in multipath environments. The proposed ultra-wideband technique is based on phase-mode expansions and the use of nearly…
This paper optimizes the beamforming design of a downlink multiple-input multiple-output (MIMO) dual-function radar-communication (DFRC) system to maximize the weighted communication sum-rate under a prescribed transmit covariance…
We propose a new technique for multiple-input multiple-output (MIMO) radar with colocated antennas which we call phased-MIMO radar. The new technique enjoys the advantages of MIMO radar without sacrificing the main advantage of phased-array…
Recently, compressive antenna arrays have been considered for DoA estimation with reduced hardware complexity. By utilizing compressive sensing, such arrays employ a linear combining network to combine signals from a larger set of antenna…
We consider a radar architecture where an illuminator composed of few sources is used as a feeder for a (passive) reconfigurable intelligent surface (RIS), so as to mimic the behavior of a multiple-input multiple-output (MIMO) radar…
In this paper, we present our spectrum sharing algorithm between a multi-input multi-output (MIMO) radar and Long Term Evolution (LTE) cellular system with multiple base stations (BS)s. We analyze the performance of MIMO radars in detecting…
Beamforming in multiple-input multiple-output (MIMO) systems should take interference mitigation into account. However, for beamform design, accurate channel state information (CSI) is needed, which is often difficult to obtain due to…
Dual-function radar communication (DFRC) systems incorporate both radar and communication functions by sharing spectrum, hardware and radio frequency (RF) chains. In this work, we consider a conceptual DFRC scheduler model which shares RF…
In recent years and with introduction of 5G cellular network and communication, researchers have shown great interest in Multiple Input Multiple Output (MIMO) communication, an advanced technology. Many studies have examined the problem of…
We consider the design of polyphase waveforms for ground moving target detection with airborne multiple-input-multiple-output (MIMO) radar. Due to the constant-modulus and finite-alphabet constraint on the waveforms, the associated design…
This paper studies spatial smoothing using sparse arrays in single-snapshot Direction of Arrival (DOA) estimation. We consider the application of automotive MIMO radar, which traditionally synthesizes a large uniform virtual array by…
In this paper, we consider a reconfigurable intelligent surface (RIS)-assisted 3D direction-of-arrival (DoA) estimation system, in which a uniform planar array (UPA) RIS is deployed to provide virtual line-of-sight (LOS) links and reflect…
In this paper, we design robust beamforming to guarantee the physical layer security for a multiuser beam division multiple access (BDMA) massive multiple-input multiple-output (MIMO) system, when the channel estimation errors are taken…