Related papers: Using Bayesian Analysis and Gaussian Processes to …
The assessment of the thermal properties of walls is essential for accurate building energy simulations that are needed to make effective energy-saving policies. These properties are usually investigated through in-situ measurements of…
In this work, the inverse problem of quantitative thermoacoustic tomography is studied. In quantitative thermoacoustic tomography, dielectric parameters of an imaged target are estimated from an absorbed energy density induced by an…
Beam Emission Spectroscopy (BES) measurements of ion-scale density fluctuations in the MAST tokamak are used to show that the turbulence correlation time, the drift time associated with ion temperature or density gradients, the particle…
Room and high temperature mechanical properties of reactive magnetron sputtered TaSiN coatings were measured using nanoindentation (between 25C and 500C). Fracture toughness was also evaluated at a similar temperature range using the…
We analyse phase averaging in one-dimensional interacting mesoscopic systems with several barriers and show that for incommensurate positions an independent average over several phases can be induced by finite temperature. For three strong…
Thermal wave crystals based on the dual-phase-lag model are investigated in this paper by both theoretical analysis and numerical simulation to control the non-Fourier heat conduction process. The transfer matrix method is used to calculate…
We measure transport through a Ga[Al]As heterostructure at temperatures between 0.1 K and 30 K. Increasing the temperature enhances the electron-electron scattering rate and viscous effects in the two-dimensional electron gas arise. To…
We develop ion-ion pair potentials for Al, Na and K for densities and temperatures relevant to the warm-dense-matter (WDM) regime. Furthermore, we emphasize non-equilibrium states where the ion temperature $T_i$ differs from the electron…
We use a Monte Carlo simulation to calculate the spectra of mildly relativistic thermal plasmas in pair balance. We use the exact integral expression for the electron-positron thermal annihilation spectrum, and provide accurate expressions…
To test a Partial Equilibration Scenario (PES) of Ritort and colleagues, we do Monte Carlo simulations of discretized-strain spin models, for four 3D martensitic structural transitions under quenches to a bath temperature $T <T_0$ below a…
We show that the colossal thermoelectric power, $S(T)$, observed in the correlated semiconductor FeSb$_2$ below 30\,K is accompanied by a huge Nernst coefficient $\nu(T)$ and magnetoresistance MR$(T)$. Markedly, the latter two quantities…
Accurate predictions of inclusive scattering cross sections in the linear response regime require efficient and controllable methods to calculate the spectral density in a strongly-correlated many-body system. In this work we reformulate…
We have combined the Boltzmann transport equation with an {\it ab initio} approach to compute the thermoelectric coefficients of semiconductors. Electron-phonon, ionized impurity, and electron-plasmon scattering rates have been taken into…
The mean motion of turbulent patterns detected by a two-dimensional (2D) beam emission spectroscopy (BES) diagnostic on the Mega Amp Spherical Tokamak (MAST) is determined using a cross-correlation time delay (CCTD) method. Statistical…
Observations of exoplanet atmospheres in high resolution have the potential to resolve individual planetary absorption lines, despite the issues associated with ground-based observations. The removal of contaminating stellar and telluric…
An approach is demonstrated for comparing the temperature of the upper atmosphere obtained by ground-based and satellite methods. A method for calibrating ground-based instruments (Fabry-Perot interferometer) based on the data obtained and…
The relevance of tunneling two-level systems (TLS) for electron dephasing in metals is analyzed. We demonstrate that if the concentration of TLS is sufficient to cause the observed dephasing rate, one also should expect quite substantial…
Computational modeling is usually applied to aid experimental exploration of advanced materials to better understand the fundamental plasticity mechanisms during mechanical testing. In this work, we perform Molecular dynamics (MD)…
We propose an efficient scheme, which combines density functional theory (DFT) with deep potentials (DP), to systematically study the convergence issues of the computed electronic thermal conductivity of warm dense Al (2.7 g/cm$^3$,…
We show that by using intuitive and accessible molecular features it is possible to predict the temperature-dependent second virial coefficient of organic and inorganic compounds using Gaussian process regression. In particular, we built a…