Related papers: Silver segregation to \theta' (Al2Cu)-Al interface…
The composition and site occupancy of Mg within ordered {\delta} precipitates in a model Al Mg Li alloy have been characterized by atom probe microscopy and first-principles simulations. The concentration in the precipitates is found to be…
Age hardening induced by the formation of (semi)-coherent precipitate phases is crucial for the processing and final properties of the widely used Al-6000 alloys. Early stages of precipitation are particularly important from the fundamental…
Alloying small quantities of silver into Cu(In,Ga)Se2 was shown to improve the efficiency for wide and low band gap solar cells. We study low band gap industrial Cu(In,Ga)(S,Se)2 absorbers, substituting less than 10% of the copper with…
The grain boundary (GB) microchemistry and precipitation behaviour in high-strength Al-Zn-Mg-Cu alloys has an important influence on their mechanical and electrochemical properties. Simulation of the GB segregation, precipitation, and…
Diamond single crystals showing Infra-red features of pressurized CO2-I phase were studied using Transmission Electron Microscopy (TEM) and tomography. Numerous O-containing precipitates with sizes up to 45 nm are observed. The absolute…
Atomistic simulations are used to study linear complexion formation at dislocations in a body-centered cubic Fe-Ni alloy. Driven by Ni segregation, precipitation of the metastable B2-FeNi and stable L10-FeNi phases occurs along the…
The tensile creep performance of a polycrystalline Co/Ni-base superalloy with a multimodal gamma prime distribution has been examined at 800C and 300MPa. The rupture life of the alloy is comparable to that of RR1000 tested under similar…
The interaction between dislocations and precipitates plays an important role in the mechanical behavior of alloys. To provide more insight into the physics of this interaction, this research analyzes short-range interactions of an edge…
While lean Mg-Zn-Ca alloys are promising materials for temporary implants, questions remain on the impact of Zn and Ca. In this context, the precipitation in Mg-1.5Zn-0.25Ca (ZX20, in wt.%) was investigated upon linear heating from about…
On the base of a critical analysis of existing models for nucleation of new phase precipitates in metastable binary alloys, a new kinetic model of homogeneous nucleation and growth of alpha'-phase precipitates in Fe-Cr alloys was developed…
Segregation and dissolution behavior of Mg alloyed with Ca and Al are studied by performing density functional theory calculations considering an extensive set of surface structures and compositions. Combining ab initio surface science…
Strengthening in age-hardenable alloys is mainly achieved through nano-scale precipitates whose formation paths from the atomic-scale, solute-enriched entities are rarely analyzed and understood in a directly-verifiable way. Here, we…
Stress-driven segregation at dislocations can lead to structural transitions between different linear complexion states. In this work, we examine how platelet array linear complexions influence dislocation motion and quantify the associated…
We studied the Ag-intercalated 3D topological insulator Bi$_{2}$Se$_{3}$ by scanning tunneling microscopy/spectroscopy and angle-resolved photoemission spectroscopy, combined with a first principles calculations. We demonstrate that silver…
Dislocation interactions at the crack nucleation site were investigated in near-alpha titanium alloy Ti-6242Si subjected to low cycle fatigue. Cyclic plastic strain in the alloy resulted in dislocation pile-ups in the primary alpha grains,…
The two-dimensional dislocation dynamics approach has been recently used for analyzing plastic deformation in metals and alloys at elevated temperatures. The two-dimensional approach, however, only accounts for the dislocation climbing…
Using the stabilized jellium model with self-compression, we have calculated the dissociation energies and the barrier heights for the binary fragmentation of charged silver clusters. At each step of calculations, we have used the…
Silver interlayers have been shown to enable smooth lithium deposition and cycling in anode-free solid-state batteries. Here, we report the atomic structure of the Ag and Li interface, showing that Li preferentially plates as FCC on both…
Bimetallic alloys have drawn extensive attentions in materials science due to their widespread applications in electronics, engineering and catalysis. A very fundamental question of alloy is its surface segregation phenomenon. Many recent…
Microstructure changes during annealing of nano-crystalline silver and amorphous silicon multilayers (Ag/a-Si) have been studied by X-ray diffraction and transmission electron microscopy. The dc-magnetron sputtered Ag/a-Si multilayers…