Related papers: High-speed multicolor photometry with CMOS cameras

High-resolution dynamic X-ray detector is crucial for time-resolved digital radiography (DR) imaging and fast 3D medical computed tomography (CT) imaging. Recently, perovskites have become promising alternatives to conventional…

Context. High frame-rate imaging was employed to mitigate the effects of atmospheric turbulence (seeing) in observations of globular cluster Terzan 5. Aims. High-precision time-series photometry has been obtained with the highest angular…

Expensive scientific camera hardware is amongst the main cost factors in modern, high-performance microscopes. Recent technological advantages have, however, yielded consumer-grade camera devices that can provide surprisingly good…

We report on a new photon-counting detector possessing unprecedented spatial resolution, moderate spectral resolution and high background-rejection capability for 0.1-100 keV X-rays. It consists of an X-ray charge-coupled device (CCD) and…

We propose a practical method for radiometrically calibrating cameras using widely available gaseous tritium light sources (betalights). Along with the gain(conversion factor) and read noise level, the predictable photon flux of the source…

We provide an overview of the most important calibration aspects of the NICMOS instrument on board of HST. We describe the performance of the instrument after the installation of the NICMOS Cooling System, and show that the behavior of the…

We present a concept of the X-ray imaging system with high angular-resolution and moderate sensitivity. In this concept, a two-dimensional detector, i.e., imager, is put at a slightly out-of-focused position of the focusing mirror, rather…

In many applications, such as the detection of ultra-high energy cosmic rays using the air fluorescence method, the number of photons incident on the detector must be known. This requires a precise knowledge of the absolute efficiency of…

We present imaging data and photometry for the COSMOS survey in 15 photometric bands between 0.3um and 2.4um. These include data taken on the Subaru 8.3m telescope, the KPNO and CTIO 4m telescopes, and the CFHT 3.6m telescope. Special…

The RGB Bayer filter system consists of a mosaic of R, G, and B filters on the grid of the photo sensors which typical commercial DSLR (Digital Single Lens Reflex) cameras and CCD cameras are equipped with. Lot of unique astronomical data…

3D time-of-flight (ToF) imaging is used in a variety of applications such as augmented reality (AR), computer interfaces, robotics and autonomous systems. Single-photon avalanche diodes (SPADs) are one of the enabling technologies providing…

We present the design of a Velocity Map Imaging apparatus tailored to the demands of high-resolution crossed molecular beam experiments employing Stark or Zeeman decelerators. The key requirements for these experiments consist of the…

Here we present a high-sensitivity, rapid, and low-cost method for methane sensing based on a nonlinear interferometer. This method utilizes signal photons generated by stimulated parametric down-conversion (ST-PDC), enabling the use of a…

I will show that photometry -- if extending over a reasonable choice of passbands -- can give fairly precise information about young star clusters and their evolutionary state. Optical colors alone are known to leave severe ambiguities due…

We report the first characterization results of an optical time-stamping camera based on the Timepix4 chip coupled to a fully depleted optical silicon sensor and fast image intensifier, enabling sub-nanosecond scale, time-resolved imaging…

Advances in CMOS technology have made high resolution image sensors possible. These image sensor pose significant challenges in terms of the amount of raw data generated, energy efficiency and frame rate. This paper presents a new design…

Cosmic ray muon has strong penetrating power and no ionizing radiation hazards, which makes it an ideal probe for detecting special nuclear materials. In this paper, a high spatial resolution muon tomography system based on Micromegas…

Single atom imaging requires discrimination of weak photon count events above background and has typically been performed using either EMCCD cameras, photomultiplier tubes or single photon counting modules. sCMOS provides a cost effective…

We describe a fast data-driven optical camera, Tpx3Cam, with nanosecond scale timing resolution and 80 Mpixel/sec throughput. After the addition of intensifier, the camera is single photon sensitive with quantum efficiency determined…

Cross-grating phase microscopy (CGM) is a quantitative phase microscopy technique based on the association of a 2-dimensional diffraction grating (cross-grating) and a regular camera sensor, separated by a millimetric distance. This simple…