Related papers: High Q electromechanics with InAs nanowire quantum…
We report electrical conductance and thermopower measurements on InAs nanowires synthesized by chemical vapor deposition. Gate modulation of the thermopower of individual InAs nanowires with diameter around 20nm is obtained over T=40 to…
We present systematic measurements of the quality factors of surface acoustic wave (SAW) resonators on ST-X quartz in the gigahertz range at a temperature of $10 \, \textrm{mK}$. We demonstrate a internal quality factor $Q_\mathrm{i}$…
We report on a comprehensive study of spin-1/2 Kondo effect in a strongly-coupled quantum dot realized in a high-quality InAs nanowire. The nanowire quantum dot is relatively symmetrically coupled to its two leads, so the Kondo effect…
We have realized a hybrid solid-state quantum device in which a single-electron semiconductor double quantum dot is dipole coupled to a superconducting microwave frequency transmission line resonator. The dipolar interaction between the two…
We have explored the low-temperature linear and non-linear electrical conductance $G$ of metallic carbon nanotubes (CNTs), which were grown by the chemical-vapor deposition method. The high transparency of the contacts allows to study these…
Dissipation of micro- and nano-scale mechanical structures is dominated by quantum-mechanical tunneling of two-level defects intrinsically present in the system. We find that at high frequencies--usually, for smaller, micron-scale…
Experiments to probe the basic quantum properties of motional degrees of freedom of mechanical systems have developed rapidly over the last decade. One promising approach is to use hybrid electromechanical systems incorporating…
A new linac using superconducting quarter-wave resonators (QWR) is under construction at CERN in the framework of the HIE-ISOLDE project. The QWRs are made of niobium sputtered on a bulk copper substrate. The working frequency at 4.5 K is…
Conductance through a system consisting of a wire with side-attached quantum dots is calculated. Such geometry of the device allows to study the coexistence of quantum interference, electron correlations and their influence on conductance.…
We performed measurements at helium temperatures of the electronic transport in an InAs quantum wire ($R_{wire} \sim 30$\,k$\Omega$) in the presence of a charged tip of an atomic force microscope serving as a mobile gate. The period and the…
Electron transport through parallel double quantum dot system with interdot tunneling and strong on-site Coulomb interaction is studied in the Kondo regime by using the finite-$U$ slave boson technique. For a system of quantum dots with…
Several experiments have recently reported on gate-tunable superconducting properties in metallic devices, holding promise for the realization of cryogenic switches, tunable resonators, and superconducting logic. In particular, the…
We study the microwave impedance of extremely high aspect ratio (length/width ~ 5,000) superconducting niobium nitride nanowires. The nanowires are fabricated in a compact meander geometry that is in series with the center conductor of a 50…
We have measured the diagonal conductivity in the microwave regime of an ultrahigh mobility two dimensional electron system. We find a sharp resonance in Re[sigma_{xx}] versus frequency when nu > 4 and the partial filling of the highest…
An integrated photonic platform is proposed for strong interactions between atomic beams and annealing-free high-quality-factor (Q) microresonators. We fabricated a thin-film, air-clad SiN microresonator with a loaded Q of $1.55\times10^6$…
The low-frequency shot noise properties of two electrostatically coupled semiconductor quantum dot states which are connected to emitter/collector contacts are studied. A master equation approach is used to analyze the bias voltage…
Electron tunneling through small metallic islands with low capacitance is studied. The large charging energy in these systems is responsible for nonperturbative Coulomb blockade effects. We further consider the effect of electron…
The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting…
Suspended aluminium nanoelectromechanical resonators have been fabricated, and the manufacturing process is described in this work. Device motion is driven and detected with a magnetomotive method. The resonance response has been measured…
Single electron transistors (SETs) made from single wall carbon nanotubes (SWCNTs) are promising for quantum electronic devices operating with ultra-low power consumption and allow fundamental studies of electron transport. We report on…