Related papers: Low noise constant current source for bias depende…
We present the design process and implementation of fully open-source, ultra-low noise programmable current source systems in two configurations. Although originally designed as coil drivers for Optically Pumped Magnetometers (OPMs), the…
Noisy voltage sources can be a limiting factor for fundamental physics experiments as well as for device applications in quantum information, mesoscopic circuits, magnetometry, and other fields. The best commercial DC voltage sources can be…
For the generation of static magnetic fields solenoids are frequently used for the purpose of research and development of magnetic field sensors. When such a sensor is to be analyzed with regard to its inherent noise the influence of other…
A low cost, stable, programmable, unipolar current source is described. The circuit is designed in view of a modular arrangement, suitable for applications where several DC sources must be controlled at once. A hybrid switching/linear…
We describe and characterize a simple, low cost, low phase noise microwave source that operates near 6.800 GHz for agile, coherent manipulation of ensembles of 87Rb. Low phase noise is achieved by directly multiplying a low phase noise 100…
Nanopositioning techniques currently applied to characterize physical properties of materials interesting for applications at the microscopic scale rely on high-voltage electronic control circuits that should have the lowest possible noise…
This article analyzes the design of a low-noise amplifier intended as the input front-end for the measurement of the low-frequency components (below 10 Hz) of a 50 Ohm source. Low residual flicker is the main desired performance. This…
In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on…
An ultrastable low-noise current amplifier (ULCA) is presented. The ULCA is a non-cryogenic instrument based on specially designed operational amplifiers and resistor networks. It involves two stages, the first providing a 1000-fold current…
The design and performance of a sensitive and reliable cross-correlation spectrum analyzer for studying low frequency transport noise is described in detail. The design makes use of common PC-based data acquisition hardware and…
Noise parameters are a set of four measurable quantities which determine the noise performance of a radio-frequency device under test. The noise parameters of a 2-port device can be extracted by connecting a set of 4 or more source…
We present a new method to measure 1/f noise in Josephson quantum bits (qubits) that yields low-frequency spectra below 1Hz. Comparison of noise taken at positive and negative bias of a phase qubit shows the dominant noise source to be flux…
A transimpedance amplifier has been designed for scanning tunneling microscopy (STM). The amplifier features low noise (limited by the Johnson noise of the 1 G{\Omega} feedback resistor at low input current and low frequencies), sufficient…
Randomization of the trap state of defects present at the gate Si-SiO$_2$ interface of MOSFET is responsible for the low-frequency noise phenomena such as Random Telegraph Signal (RTS), burst, and 1/\textit{f} noise. In a previous work,…
1/f noise in current biased La0.82Ca0.18MnO3 crystals has been investigated. The temperature dependence of the noise follows the resistivity changes with temperature suggesting that resistivity fluctuations constitute a fixed fraction of…
We describe the construction and operation of a two-channel noise detection system for measuring power and cross spectral densities of current fluctuations near 2 MHz in electronic devices at low temperatures. The system employs cryogenic…
The current noise in a multi-probe mesoscopic conductor can have a nonlinear dependence on the strength of driving bias voltage. This paper presents a theoretical formulation for the nonlinear noise spectra. We pay special attention to…
The resolution of low-frequency resistance noise measurements can be increased by amplitude modulation, shifting the spectrum of the resistance fluctuations away from the 1/f noise contributed by measurement instruments. However, commercial…
We present here a short review of mainly experimental properties of noise as disordered systems are driven into non-ohmic regimes by applying voltages of few volts only. It is found that the noise does not simply follow the resistance in…
A new mechanism of low frequency (1/f-like) noise generation is described and analyzed. It is attributed to higher frequency asymmetric resonance modes, which are stimulated by a random factor, e.g. due to thermal excitation.…