Related papers: Low noise constant current source for bias depende…
A single electron transistor based on Al-AlO_x-Nb tunnel junctions was fabricated by shadow evaporation and in situ barrier formation. Its output current noise was measured, using a transimpedance amplifier setup, as a function of bias…
In this letter, we present a study of optimized TMR magnetic field sensors as a function of voltage bias. The 1/f low-frequency noise is quantified by the Hooge-like parameter {\alpha} which allows to compare the low-frequency behavior of…
In gate-defined quantum dot systems, the conductance change of electrostatically coupled sensor dots allows the observation of the quantum dots' charge and spin states. Therefore, the sensor dot must be optimally sensitive to changes in its…
We discuss theoretically a setup where a time-dependent current consisting of a DC bias and two sinusoidal harmonics is driven through a sample. If the sample exhibits current-dependent shot noise, the down-converted noise power spectrum…
A low-noise amplifier (LNA) amplifies a very low-power signal without significantly degrading its signal-to-noise ratio. This paper provides the design of a linear low noise amplifier with the transistor BFP 640 using bilateral approach…
The generation and manipulation of ultracold atomic ensembles in the quantum regime require the application of dynamically controllable microwave fields with ultra-low noise performance. Here, we present a low-phase-noise microwave source…
We present a current monitoring system based on optical magnetometry, which is able to discriminate true current variations from environmental effects at room temperature. The system consists of a dedicated thermally stable magnetic field…
This paper describes the setup and the results of the direct on-wafer measurements of a FET noise parameters obtained with a source-pull method at temperatures down to T=4K and in the 5-12 GHz frequency range. The setup consists of a…
The noise spectra associated with correlations of the current through a single level quantum dot, and with the charge fluctuations on the dot, are calculated for a finite bias voltage. The results turn out to be sensitive to the asymmetry…
Conductivity noise in dc current biased La_{0.82}Ca_{0.18}MnO_{3} single crystals has been investigated in different metastable resistivity states enforced by applying voltage pulses to the sample at low temperatures. Noise measured in all…
Transition-edge sensors (TESs) are sensitive devices for detecting photons from millimeter radiation to gamma rays. Their photon counting efficiency and collecting area benefit from large-array multiplexing scheme, and therefore the…
This paper presents an output capacitor-less low-dropout regulator (LDO) with a bias switching scheme for biomedical applications with dual-range load currents. Power optimization is crucial for systems with multiple activation modes such…
We describe a set up for measurements of low frequency (1 mHz < f < 20 Hz) conductance fluctuations in a solid conductor. The set-up uses a five probe a.c. measurement technique and extensive digital signal processing to reach a noise floor…
Charge noise is one of the main sources of environmental decoherence for spin qubits in silicon, presenting a major obstacle in the path towards highly scalable and reproducible qubit fabrication. Here we demonstrate in-depth…
We developed a high-speed and low-noise time-domain current measurement scheme using a homemade GaAs high-electron-mobility-transistor-based cryogenic transimpedance amplifier (TIA). The scheme is versatile for broad cryogenic current…
We present an approach to compute stabilizing controllers for continuous-time linear time-invariant systems directly from an input-output trajectory affected by process and measurement noise. The proposed output-feedback design combines (i)…
We have designed low noise temperature sensing and control units with the objective of using them for the fabrication of far infrared active cavity radiometers. The sensing unit, first characterized at 300K using industrial platinium…
New technology, the ultrastable low-noise current amplifier and the electron pump, provide new methods for making traceable measurements of small DC electric currents. We review four traceability routes for small current measurements and…
Many modern electronic devices utilize linear Hall sensors to measure current and the magnetic field, as well as to perform switching and latching operations. Smartphones, laptops, and e-readers all work with very low (sub-mA) currents. To…
A current bias dc SQUID behaves as an anharmonic quantum oscillator controlled by a bias current and an applied magnetic flux. We consider here its two level limit consisting of the two lower energy states $| 0 \right>$ and $| 1 \right>$.…