Related papers: Zero-cell photonic crystal nanocavity laser with q…
We demonstrate a photonic crystal nanocavity laser essentially driven by a self-assembled InAs/GaAs single quantum dot gain. The investigated nanocavities contain only 0.4 quantum dots on an average; an ultra-low density quantum dot sample…
We demonstrate lasing oscillation in a three-dimensional photonic crystal nanocavity. The laser is realized by coupling a cavity mode, which is localized in a complete photonic bandgap and exhibits the highest quality factor of ~38,500,…
Engineering the electromagnetic environment of a nanoscale light emitter by a photonic cavity can significantly enhance its spontaneous emission rate through cavity quantum electrodynamics in the Purcell regime. This effect can greatly…
We experimentally demonstrated high quality factors (Q-factors) of nanocavities in three-dimensional photonic crystals by increasing the in-plane area of the structure. Entire structures made of GaAs were fabricated by a micro-manipulation…
The lasing behavior of one dimensional GaAs nanobeam cavities with embedded InAs quantum dots is studied at room temperature. Lasing is observed throughout the quantum dot PL spectrum, and the wavelength dependence of the threshold is…
The efficiency and operating range of a photonic crystal laser is improved by passivating the InGaAs quantum well (QW) gain medium and GaAs membrane using an (NH4)S treatment. The passivated laser shows a four-fold reduction in nonradiative…
Sub-threshold measurements of a photonic crystal (PC) microcavity laser operating at 1.3 microns show a linewidth of 0.10 nm, corresponding to a quality factor Q ~ 1.3x10^4. The PC microcavity mode is a donor-type mode in a graded square…
Efficient, low threshold, and compact semiconductor laser sources are being investigated for many applications in high-speed communications, information processing, and optical interconnects. The best edge-emitting and vertical cavity…
We fabricate and experimentally characterize a $H0$ photonic crystal slab nanocavity with a design optimized for maximal quality factor, $Q = 1.7$ million. The cavity, fabricated from a silicon slab, has a resonant mode at $\lambda = 1.59…
We demonstrate experimentally an air-slot mode-gap photonic crystal cavity with quality factor of 15,000 and modal volume of 0.02 cubic wavelengths, based on the design of an air-slot in a width-modulated line-defect in a photonic crystal…
We have demonstrated an up to seven-fold enhancement of photoluminescence from silicon-rich silicon nitride film due to a single photonic crystal cavity. The enhancement is partially attributed to the Purcell effect. Purcell factor…
We demonstrate that very few (1 to 3) quantum dots as a gain medium are sufficient to realize a photonic crystal laser based on a high-quality nanocavity. Photon correlation measurements show a transition from a thermal to a coherent light…
A photonic crystal (PhC) nanocavity formed in an optically very thick slab can support reasonably high-Q modes for lasing. Experimentally, we demonstrate room-temperature pulsed lasing operation from the PhC dipole mode emitting at 1324 nm,…
Cavities with high quality (Q) factor and small mode-volume are crucial to realize high performance nanolasers suitable for optical interconnects. In this work, we propose a novel one-dimensional photonic crystal nanobeam cavity design with…
One dimensional nanobeam photonic crystal cavities are fabricated in silicon dioxide with silicon nanocrystals. Quality factors of over 9 x 10^3 are found in experiment, matching theoretical predictions, with mode volumes of 1.5(lambda/n)^3…
We investigate the quality (Q) factor and the mode dispersion of single-defect nanocavities based on a triangular-lattice GaAs photonic-crystal (PC) membrane, which contain InAs quantum dots (QDs) as a broadband emitter. To obtain a high Q…
An H1 photonic crystal nanocavity is based on a single point defect and has eigenmodes with a variety of symmetric features. Thus, it is a promising building block for photonic tight-binding lattice systems that can be used in studies on…
We present the design of a femtogram L3-nanobeam photonic crystal cavity for optomechanical studies. Two symmetric nanobeams are created by placing three air slots in a silicon photonic crystal slab where three holes are removed. The…
We have realized and measured a GaAs nanocavity in a slab photonic crystal based on the design by Kuramochi et al. [Appl. Phys.Lett., \textbf{88}, 041112, (2006)]. We measure a quality factor Q=700,000, which proves that ultra-high Q…
Epitaxial III-V semiconductor quantum dots in nanopthonic structures are promising candidates for implementing on-demand indistinguishable single-photon emission in integrated quantum photonic circuits. Quantum dot proximity to the etched…