Related papers: Minimal resonator loss for circuit quantum electro…
Dielectrics with low loss at microwave frequencies are imperative for high-coherence solid-state quantum computing platforms. We study the dielectric loss of hexagonal boron nitride (hBN) thin films in the microwave regime by measuring the…
Superconducting resonators used in millimeter-submillimeter astronomy would greatly benefit from deposited dielectrics with a small dielectric loss. We deposited hydrogenated amorphous silicon films using plasma-enhanced chemical vapor…
$\alpha$-Tantalum ($\alpha$-Ta) is an emerging material for superconducting qubit fabrication due to the low microwave loss of its stable native oxide. However, hydrogen absorption during fabrication, particularly when removing the native…
High quality micro- and nano-mechanical resonators are widely used in sensing, communications and timing, and have future applications in quantum technologies and fundamental studies of quantum physics. Crystalline thin-films are…
We report on the fabrication and characterization of superconducting coplanar waveguide (CPW) resonators based on titanium nitride (TiN) thin films deposited on 200\,mm diameter high-resistivity Si(100) substrates. We systematically…
Mechanical resonators made with monolithic piezoelectric quartz crystals are promising for studying new physical phenomena. High mechanical quality factors ($Q$) exhibited by the mm-sized quartz resonators make them ideal for studying weak…
The coherence of state-of-the-art superconducting qubit devices is predominantly limited by two-level-system defects, found primarily at amorphous interface layers. Reducing microwave loss from these interfaces by proper surface treatments…
We present in this letter terahertz (THz) metamaterials with low ohmic losses made from low-temperature superconductor niobium nitride (NbN) films. The resonance properties are characterized by THz time-domain spectroscopy. The unloaded…
The recent emergence of thin-film lithium niobate (TFLN) has extended the landscape of integrated photonics. This has been enabled by the commercialization of TFLN wafers and advanced nanofabrication of TFLN such as high-quality dry…
We demonstrate wideband integrated photonic circuits in sputter-deposited aluminum nitride (AlN) thin films. At both near-infrared and visible wavelengths, we achieve low propagation loss in integrated waveguides and realize high-quality…
We experimentally investigated the optical responses of a superconducting niobium resonator. It was found that, with increasing radiation power, the resonance frequency increases monotonically below around 500 mK, decreases monotonically…
A quantum-limited amplification chain is a fundamental advantage for any application that may benefit from the detection of very faint signals. Reading out arrays of superconducting detectors (TESs or MKIDs), resonant cavities, or qubits,…
For practical superconducting quantum processors, orders of magnitude improvement in coherence is required, motivating efforts to optimize hardware design and explore new materials. Among the latter, the coherence of superconducting…
Low noise single-photon sources are a critical element for quantum technologies. We present a heralded single-photon source with an extremely low level of residual background photons, by implementing low-jitter detectors and electronics and…
Low-loss waveguides are required for quantum communication at distances beyond the chip-scale for any low-temperature solid-state implementation of quantum information processors. We measure and analyze the attenuation constant of…
We simulate and experimentally demonstrate the existence of an orientation of quartz which minimizes diffraction losses in surface acoustic wave (SAW) resonators at ultra-low temperatures. The orientation is optimized for applications to…
We present a lab-on-chip experiment to accurately measure losses of superconducting microstrip lines at microwave and sub-mm wavelengths. The microstrips are fabricated from NbTiN, which is deposited using reactive magnetron sputtering, and…
Here we present the microwave characterization of microstrip resonators made from aluminum and niobium inside a 3D microwave waveguide. In the low temperature, low power limit internal quality factors of up to one million were reached. We…
The microwave properties of a crystalline sapphire dielectric whispering gallery mode resonator have been measured at very low excitation strength (E/hf=1) and low temperatures (T = 30 mK). The measurements were sensitive enough to observe…
We demonstrate ultra-high Q factor microring resonators close to the intrinsic material absorption limit on lithium niobate on insulator. The microrings are fabricated on pristine lithium niobate (LN) thin film wafer thinned from LN bulk…