Related papers: Cryogenic instrumentation for fast current measure…
We have developed an efficient cryogenic system with heat exchange and associated gas purification system, as a prototype for the XENON1T experiment. The XENON1T detector will use about 3 ton of liquid xenon (LXe) at a temperature of 175K…
We report the instrumentation and experimental results of a cryogenic scanning microwave impedance microscope. The microwave probe and the scanning stage are located inside the variable temperature insert of a helium cryostat. Microwave…
Scanning Superconducting QUantum Interference Device (SQUID) microscopy is a powerful tool for imaging local magnetic properties of materials and devices, but it requires a low-vibration cryogenic environment, traditionally achieved by…
The design of single chip current source based on a common power operational amplifier is presented and demonstrated for the purpose of controlling applied magnetic fields using bias/shim electromagnets in cold atom experiments. The…
Recent advances in far-infrared detector technology have led to increases in raw sensitivity of more than an order of magnitude over previous state-of-the-art detectors. With such sensitivity, photon noise becomes the dominant noise…
Radiation hard helium gas ionization chambers capable of operating in vacuum at temperatures ranging from 5K to 350K have been designed, fabricated and tested and will be used inside the cryostats at Fermilab's Superconducting…
We have used two types of thermometry to study thermal fluctuations in a microcantilever-based system below 1 K. We measured the temperature of a cantilever's macroscopic degree-of-freedom (via the Brownian motion of its lowest flexural…
Microwave experiments in dilution refrigerators are a central tool in the field of superconducting quantum circuits and other research areas. This type of experiments relied so far on attaching a device to the mixing chamber of a dilution…
Single-photon imaging spectrometers of high quantum efficiency in the infrared to ultraviolet wavelength range, with good timing resolution and with a vanishing dark count rate are on top of the wish list in earth-bound astronomy, material…
Large power consumption of silicon CMOS electronics is a challenge in very-large-scale integrated circuits and a major roadblock to fault-tolerant quantum computation. Matching the power dissipation of Si-MOSFETs to the thermal budget at…
The nitrogen-vacancy (NV) center in diamond has been recognized as a high-sensitivity nanometer-scale metrology platform. Thermometry has been a recent focus, with attention largely confined to room temperature applications. Thermometry has…
Fabrication of dielectrics at low temperature is required for temperature-sensitive detectors. For superconducting detectors, such as transition edge sensors and kinetic inductance detectors, AlMn is widely studied due to its variable…
Reflection measurements give access to the complex impedance of a material on a wide frequency range. This is of interest to study the dynamical properties of various materials, for instance disordered superconductors. However reflection…
The measurements of very low level signals at low frequency is a very difficult problem, because environmental noise increases in this frequency domain and it is very difficult to filter it efficiently. In order to counteract these major…
The performance of a Si PIN diode (type Hamamatsu S3590-06) as an energy sen- sitive detector operating at cryogenic temperatures (~10 K) and in magnetic fields up to 11 T was investigated, using a 207Bi conversion electron source. It was…
We show that fast technical fluctuations of microwave signals can be strongly suppressed by cryogenic resonators. The experiments were carried out with sapphire resonators cooled to approximately 6 K at frequencies around 11 GHz. Each…
This paper presents a low noise amplifier for large arrays of silicon photomultipliers (SiPMs) operated in cryogenic environments, especially liquid argon (87 K) and liquid nitrogen (77 K). The goal is for one amplifier to read out a total…
Understanding the microscopic thermal effects of the hydrogel is important for its application in diverse fields, including thermal-related studies in tissue engineering and thermal management for flexible electronic devices. In recent…
The reliable measurement and accurate control of the temperature within nanophotonic devices is a key prerequisite for their application in both classical and quantum technologies. Established approaches use sensors that are attached in…
Reducing the operating temperature of normal conducting particle accelerators substantially increases their efficiency. Low-temperature operation increases the yield strength of the accelerator material and reduces surface resistance, hence…