Related papers: Flexible Micro Thermoelectric Generator based on E…
Differential thermal analysis up to complete melting was performed for the complete pseudobinary system LiF-BiF3. Melts with high bismuth fluoride concentration show severe evaporation, nevertheless even pure BiF3 could be molten at 655…
Thermoelectric power generators are used to convert heat into electricity. Like any other heat engine, the performance of a thermoelectric generator increases as the temperature difference on the sides increases. It is generally assumed…
We present a new method to obtain topological insulator Bi$_2$Se$_3$ thin films with a centimeter large lateral length. To produce amorphous Bi$_2$Se$_3$ thin films we have used a sequential flash-evaporation method at room temperature.…
We demonstrate tunable solid state and flexible graphene field effect devices (FEDs) fabricated using a poly(methylmethacrylate) (PMMA) and lithium fluoride (LiF) composite dielectric. Increasing the concentration of LiF in the composite…
Electroplated Bismuth (Bi) is commonly used in Transition-Edge Sensors (TESs) for X-rays because of its high stopping power and low heat capacity. Electroplated Bi is usually grown on top of another metal that acts as seed layer, typically…
Thermal micro-actuators are a promising solution to the need for large-displacement, gentle handling force, low-power MEMS actuators. Potential applications of these devices are micro-relays, assembling and miniature medical…
We study the low-temperature thermopower of micron sized, free-standing membranes containing a two-dimensional electron system. Suspended membranes of 320 nm thickness including a high electron mobility structure in Hall bar geometry of 34…
Extended from its electromagnetic counterpart, transformation thermodynamics applied to thermal conduction equations can map a virtual geometry into a physical thermal medium, realizing the manipulation of heat flux with almost arbitrarily…
In this work, we have designed and simulated new thermoelectric generator based on monolayer and few-layer MoS2 nanoribbons. The proposed thermoelectric generator is composed of thermocouples made of both n-type and p-type MoS2 nanoribbon…
This study examines the magnetotransport response observed in flakes of the 3D topological insulator (TI) Bi2Te3, including indium superconducting electrodes, and demonstrates two critical transitions in the magnetoresistive response with…
A novel microfabricated, all-electrical measurement platform is presented for a direct, accurate and rapid determination of the thermal conductivity and diffusivity of liquid and solid materials. The measurement approach is based on the…
In this article we report on the design, fabrication and tests of micro-fabricated broadband filters suitable for proper electromagnetic thermalization of electrical lines connected to sensitive quantum electronics experiments performed at…
Water-free NH4V3O8 microcrystals have been successfully synthesized by a microwave-assisted hydrothermal method. The products were characterized by means of X-ray diffraction, scanning electron microscopy, Fourier transform infrared…
This paper presents a micro electrostatic vibration-toelectricity energy converter. For the 3.3 V supply voltage and 1cm2 chip area constraints, optimal design parameters were found from theoretical calculation and Simulink simulation. In…
SMES using high critical temperature superconductors are interesting for high power pulsed sources. Operation at temperatures above 20 K makes cryogenics easier, enhances stability and improves operation as pulsed power source. In the…
We report a novel synthesis for near monodisperse, sub-10-nm Bi2Te3 nanoparticles. At first, a new reduction route to bismuth nanoparticles is described which are applied as starting materials in the formation of rhombohedral Bi2Te3…
Electrical field control of the carrier density of topological insulators (TI) has greatly expanded the possible practical use of these materials. However, the combination of low temperature local probe studies and a gate tunable TI device…
We present electrothermal microelectromechanical (MEMS) actuators as a practical platform for straining 2D materials. The advantages of the electrothermal actuator is its high output force and displacement for low input voltage, but its…
Thermoelectric energy conversion is an attractive technology for generating electricity from waste heat and using electricity for solid-state cooling. However, conventional manufacturing processes for thermoelectric devices are costly and…
We measure gate-tuned thermoelectric power of mechanically exfoliated Bi2Se3 thin films in the topological insulator regime. The sign of the thermoelectric power changes across the charge neutrality point as the majority carrier type…