Related papers: High quality factor gigahertz frequencies in nanom…
We present nanofabrication and mechanical measurements of single-crystal diamond cantilevers with thickness down to 85 nm, thickness uniformity better than 20 nm, and lateral dimensions up to 240 um. Quality factors exceeding one million…
Resonance properties of nanomechanical resonators based on doubly clamped silicon nanowires, fabricated from silicon-on-insulator and coated with a thin layer of aluminum, were experimentally investigated. Resonance frequencies of the…
In this work we present the fabrication and characterization of superconducting nano-mechanical resonators made from nanocrystalline boron doped diamond (BDD). The oscillators can be driven and read out in their superconducting state and…
With its host of outstanding material properties, single-crystal diamond is an attractive material for nanomechanical systems. Here, the mechanical resonance characteristics of freestanding, single-crystal diamond nanobeams fabricated by an…
Carbon nanotube mechanical resonators have attracted considerable interest because of their small mass, the high quality of their surface, and the pristine electronic states they host. However, their small dimensions result in fragile…
High-stress Si$_3$N$_4$ nanoresonators have become an attractive choice for electro- and optomechanical devices. Membrane resonators can achieve quality factor ($Q$) - frequency ($f$) products exceeding $10^{13}$ Hz, enabling (in principle)…
We report the design, fabrication, and characterization of diamond cantilevers attached to a phononic square lattice. We show that the robust protection of mechanical modes by phononic band gaps leads to a three-orders-of-magnitude increase…
We have measured the dissipation and frequency of nanocrystalline-diamond nanomechanical resonators with resonant frequencies between 13.7 MHz and 157.3 MHz, over a temperature range of 1.4-274 K. Using both magnetomotive network analysis…
Single-crystal diamond is a promising material for MEMs devices because of its low mechanical loss, compatibility with extreme environments, and built-in interface to high-quality spin centers. But its use has largely been limited by…
We report ring resonators on a silicon germanium on silicon platform operating in the mid-infrared wavelength range around 3.5 - 4.6 {\mu}m with quality factors reaching up to one million. Advances in fabrication technology enable us to…
The realization and characterization of a high quality factor resonator composed of two hollow-dielectric cylinders with its pseudo-TM$_{030}$ mode resonating at 10.9 GHz frequency is discussed. The quality factor was measured at the…
We present an integrated scheme for dielectric drive and read-out of high-Q nanomechanical resonators which enables tuning of both the resonance frequency and quality factor with an applied DC voltage. A simple model for altering these…
Mechanical resonances are used in a wide variety of devices; from smart phone accelerometers to computer clocks and from wireless communication filters to atomic force microscope sensors. Frequency stability, a critical performance metric,…
We report disk-shaped silicon optomechanical resonators with frequency up to 1.75 GHz in the ultrahigh frequency band. Optical transduction of the thermal motion of the disks' in-plane vibrational modes yields a displacement sensitivity of…
Milligram-scale resonators have been shown to be suitable for the creation of 3-mode optoacoustic parametric amplifiers, based on a phenomena first predicted for advanced gravitational-wave detectors. To achieve practical optoacoustic…
We report on a simple method to fabricate high-frequency nanotube mechanical resonators reproducibly. We measure resonance frequencies as high as 4.2 GHz for the fundamental eigenmode and 11 GHz for higher order eigenmodes. The…
High-aspect-ratio mechanical resonators are pivotal in precision sensing, from macroscopic gravitational wave detectors to nanoscale acoustics. However, fabrication challenges and high computational costs have limited the…
Systems with low mechanical dissipation are extensively used in precision measurements such as gravitational wave detection, atomic force microscopy and quantum control of mechanical oscillators via opto- and electromechanics. The…
Recent progress in nanoscale optical physics is associated with the development of a new branch of nanophotonics exploring strong Mie resonances in dielectric nanoparticles with high refractive index. The high-index resonant dielectric…
We present a silicon optomechanical nanobeam design with a dynamically tunable acoustic mode at 10.2 GHz. The resonance frequency can be shifted by 90 kHz/V^2 with an on-chip capacitor that was optimized to exert forces up to 1 $\mu$N at 10…