Related papers: Superconducting MgB2 thin films nano-bridges for c…
The critical current density of four MgB2 samples was measured inductively and for one of them also by transport. Pure phased and dense bulk samples yield a critical current density which in value, as well as in its magnetic field and…
The paper presents discussion on up to date results on MgB2 conductors from the point of view of their future dc and ac applications. Basic physical parameters of MgB2 compound relevant to conductors are introduced. Different conductor…
We report on study of the electronic anisotropy of the newly discovered MgB2 superconductor using the in-plane resistivity measurements in magnetic field applied perpendicular and parallel to Mg and B planes of MgB2 single crystals. The…
Thin-film-like high temperature superconducting Bi2Sr2CaCu2O8+x single crystals (TSB) with a typical thickness of 20-200 nm is produced by mechanical exfoliation. The TSB, which shows excellent superconductivity, can adhere firmly to the…
Scanning transmission x-ray microscopy has been used to image electric currents in superconducting films at temperatures down to 20 K. The magnetic stray field of supercurrents in a thin YBaCuO film is mapped into a soft-magnetic coating of…
Nanocrystalline MgB$_2$ produced by mechanical alloying has been shown to exhibit enhanced superconducting properties such as increased pinning and higher critical currents. However, the effects of the synthesis process on the intrinsic…
An environmentally stable mesoscopic thin film of Au of certain thickness has been deposited thermally on top of a Ag+ implanted oxide substrate to develop a close to room temperature superconductor. This thin film has been deposited in two…
Biaxially textured LuNi2BC thin films with Tc up to 15.8 K and a residual resistivity ratio up to 15 have been prepared. The films were deposited on MgO(110) substrates using pulsed laser deposition from a stoichiometric target. Via the…
High quality bulk MgB2 exhibit a structure of voids and agglomeration of crystals on different length-scales. Because of this, the superconducting currents percolate between the voids in the ensuing structure. Magnetic measurements reveal…
High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature…
Continuous Nb wires, 7-15 nm in diameter, have been fabricated by sputter-coating single fluorinated carbon nanotubes. Transmission electron microscopy revealed that the wires are polycrystalline, having grain sizes of about 5 nm. The…
MgB2 superconducting wires with critical temperature Tc approaching 40 K were used for preparation of MgB2/Ag and MgB2/In junctions. The differential conductance vs. voltage characteristics of N-S junctions exhibit clear contribution of…
MgB2 tapes and wires were fabricated by the Powder-In-Tube method. Stainless steel and Cu-Ni tubes were used as sheath materials, and no heat treatment was applied. The tapes made of stainless steel showed transport critical current density…
A series of MgB2 thin films were fabricated by pulsed laser deposition (PLD), doped with various amounts of Si up to a level of 18wt%. Si was introduced into the PLD MgB2 films by sequential ablation of a stoichiometric MgB2 target and a Si…
This is the first review on superconducting MgB2 thin films as far as we know.
We present experimental results of the upper critical fields $H_{\rm c2}$ of various MgB$_2$ thin films prepared by the molecular beam epitaxy, multiple-targets sputtering, and co-evaporation deposition apparatus. Experimental data of the…
Measurements of the superconducting upper critical field, H_{c2}, and critical current density, J_c, have been carried out for MgB_2 doped with Ti and/or C in order to explore the problems encountered if these dopants are used to enhance…
We have developed scanning near-field microwave microscopes which can image electrodynamic properties of superconducting materials on length scales down to about 2 $\mu$m. The microscopes are capable of quantitative imaging of sheet…
Conventional electron beam lithography has been used to fabricate mesoscopic Nb wires with a superconducting transition temperature above 7.0 K. The typical line width and the thickness were 200 nm and 45 nm respectively. Nb was deposited…
We have investigated the resistive response of high Tc thin films submitted to a high density of current. For this purpose, current pulses were applied into bridges made of Nd(1.15)Ba(1.85)Cu3O7 and Bi2Sr2CaCu2O8. By recording the time…