Related papers: New frequency-modulation readout based on relaxati…
Microwave frequency domain multiplexing is a suitable technique to read out a large number of detector channels using only a few connecting lines. In the HOLMES experiment this is based on inductively coupled rf-SQUIDs (Superconducting…
A new approach was developed for the design of front-end circuits for semiconductor radiation detectors. The readout scheme consists of a first stage made of only a few components located close to the detector, and of a remote second stage…
Large arrays of cryogenic detectors, including transition-edge sensors (TESs) or magnetic micro-calorimeters (MMCs), are needed for future experiments across a wide range of applications. Complexities in integration and cryogenic wiring…
We have embedded a small Josephson junction in a microwave resonator that allows simultaneous dc biasing and dispersive readout. Thermal fluctuations drive the junction into phase diffusion and induce a temperature-dependent shift in the…
Arrays of low-temperature microcalorimeters provide a promising technology for X-ray astrophysics: the imaging spectrometer. A camera with at least several thousand pixels, each of which has an energy-resolving power ($E/\Delta…
Based on the principles of microwave circuit interferometry we have constructed a Reduced Noise Amplifier (RNA) with power spectral density of phase, as well as amplitude, fluctuations close to -170 dBc/Hz at 1 kHz offset. The RNA has been…
Resonant frequency modulation spectroscopy has been previously used as a highly-sensitive method for measuring the output of cold atom interferometers. Using a detailed model that accounts for optical saturation, laser intensities and…
We report on the development of a frequency modulatable 795 nm semiconductor laser based on self-injection locking to a high quality factor whispering gallery mode microresonator. The laser is characterized with residual amplitude…
We present a unified approach for designing a diverse range of superconducting non-reciprocal components, including circulators, isolators, and uni-directional amplifiers, based on temporally-modulated coupled resonator networks. Our method…
This work reports the performance evaluation of an SDR readout system based on the latest generation (Gen3) of the AMD's Radio Frequency System-on-Chip (RFSoC) processing platform, which integrates a full-stack processing system and a…
A nanomechanical resonator coupled to a tunnel junction is studied. The oscillator modulates the transmission of the junction, changing the current and the noise spectrum. The influence of the oscillator on the noise spectrum of the…
We introduce a multimode superconducting inductor architecture that enables radio-frequency reflectometry at multiple discrete frequencies up to 2 GHz, addressing limitations of conventional single-mode designs. The spiral inductor's…
Coupled oscillator-based networks are an attractive approach for implementing hardware neural networks based on emerging nanotechnologies. However, the readout of the state of a coupled oscillator network is a difficult challenge in…
An important desired ingredient of superconducting quantum circuits is a readout scheme whose complexity does not increase with the number of qubits involved in the measurement. Here, we present a readout scheme employing a single microwave…
A circuit-simulation-based method is used to determine the thermally-induced bit error rate of superconducting logic circuits. Simulations are used to evaluate the multidimensional Gaussian integral across noise current sources attached to…
The quantum state of light changes its nature when being reflected off a mechanical oscillator due to the latter's susceptibility to radiation pressure. As a result, a coherent state can transform into a squeezed state and can get entangled…
We have implemented a resonant circuit that uses a SQUID as a flux-sensitive Josephson inductor for qubit readout. In contrast to the conventional switching current measurement that generates undesired quasi-particles when the SQUID…
We present a cryogenic microwave noise source with a characteristic impedance of 50 $\Omega$, which can be installed in a coaxial line of a cryostat. The bath temperature of the noise source is continuously variable between 0.1 K and 5 K…
A technological milestone for experiments employing Transition Edge Sensor (TES) bolometers operating at sub-kelvin temperature is the deployment of detector arrays with 100s--1000s of bolometers. One key technology for such arrays is…
We developed a high-speed and low-noise time-domain current measurement scheme using a homemade GaAs high-electron-mobility-transistor-based cryogenic transimpedance amplifier (TIA). The scheme is versatile for broad cryogenic current…