Related papers: Advanced configuration of gravitational-wave inter…
We describe an atom interferometric gravitational wave detector design that can operate in a resonant mode for increased sensitivity. By oscillating the positions of the atomic wavepackets, this resonant detection mode allows for coherently…
A scheme of an ultra-sensitive magnetometer in the cavity quantum electromagnonics where the intracavity microwave mode coupled to a magnonic mode via magnetic dipole interaction is proposed. It is shown that by driving both magnonic and…
The future laser interferometric gravitational-wave detectors sensitivity can be improved using squeezed light. In particular, recently a scheme which uses the optical field with frequency dependent squeeze factor, prepared by means of a…
We investigate novel approach, which improves the sensitivity of gravitational wave (GW) interferometer due to stochastic resonance (SR) phenomenon, performing in additional nonlinear cavity (NC). The NC is installed in the output of…
The effect of gravitational waves (GWs) has been observed indirectly, by monitoring the change in the orbital frequency of neutron stars in a binary system as they lose energy via gravitational radiation. However, GWs have not yet been…
The detection of high-frequency gravitational waves around kHz is critical to understanding the physics of binary neutron star mergers. A new interferometer design has been proposed in [Phys. Rev. X {\bf 13}, 021019 (2023)], featuring an…
Current gravitational-wave (GW) detectors are limited in the amount of circulating power they can reach. Optical absorption in the test masses leads to thermal effects that shift the eigenmodes of the optical cavities, and cause control…
In order to expand the astrophysical reach of gravitational wave detectors, several interferometer topologies have been proposed to evade the thermodynamic and quantum mechanical limits in future detectors. In this work, we make a…
The ``optical springs'' regime of the signal-recycled configuration of laser interferometric gravitational-wave detectors is analyzed taking in account optical losses in the interferometer arm cavities. This regime allows to obtain…
The direct detection of gravitational waves (GWs) of frequencies above MHz has recently received considerable attention. In this work we present a precise study of the reach of a cubic cavity resonator to GWs in the microwave range, using…
Only a few years ago, it was realized that the zero-area Sagnac interferometer topology is able to perform quantum nondemolition measurements of position changes of a mechanical oscillator. Here, we experimentally show that such an…
Recently, the hybridization of microwave-frequency cavity modes with collective spin excitations attracted large interest for the implementation of quantum computation protocols, which exploit the transfer of information among these two…
Thermal lensing in resonant optical interferometers such as those used for gravitational wave detection is a concern due to the negative impact on control signals and instrument sensitivity. In this paper we describe a method for monitoring…
Recently, the design of a white-light-cavity has been proposed using negative dispersion in an intra-cavity medium to make the cavity resonate over a large range of frequencies and still maintain a high cavity build-up. This paper presents…
The sensitivity of ground-based gravitational wave (GW) detectors will be improved in the future via the injection of frequency-dependent squeezed vacuum. The achievable improvement is ultimately limited by losses of the interferometer…
Full characterization of surface acoustic wave (SAW) devices requires imaging the spatial distribution of the acoustic field, which is not possible with standard all-electrical measurements where an interdigital transducer (IDT) is used as…
We give a detailed treatment of electromagnetic signals generated by gravitational waves (GWs) in resonant cavity experiments. Our investigation corrects and builds upon previous studies by carefully accounting for the gauge dependence of…
Sensitivity of gravitational-wave detectors is limited in the high-frequency band by quantum shot noise and eventually limited by the optical loss in signal recycling cavity. This limit is the main obstacle on the way to detect…
Quantum noise limits the sensitivity of precision measurement devices, such as laser interferometer gravitational-wave observatories and axion detectors. In the shot-noise-limited regime, these resonant detectors are subject to a trade-off…
We propose a new optical configuration for an interferometric gravitational wave detector based on the speedmeter concept using a sloshing cavity. Speedmeters provide an inherently better quantum-noise limited sensitivity at low frequencies…