Related papers: The Bunch Injection Controller for the PEP-II Stor…
There are six service buildings uniformly spaced along the perimeter of MI (Main Injector). A total of 18 LCW pumps were installed around the MI ring with 3 pumps per building. Approximately 8,000 GPM of LCW is required to cool magnets, bus…
PIP-II is an 800 MeV superconducting RF linear accelerator under development at Fermilab. As the new first stage in our accelerator chain, it will deliver high-power beam to multiple experiments simultaneously and thus drive Fermilab's…
The Storage Ring at the Advanced Light Source is capable of being filled in selectable buckets. Typically, 276 consecutive buckets out of 328 possible are selected. It has been found that the amount of charge injected is not uniform…
The PEP-II B Factory at SLAC has been in operation with the BABAR detector since the summer of 1999. The peak currents and luminosity steadily increased through the end of the 2000 run on October 31. By that time, 0.75 A of electrons (the…
In order to double the positron injection rate into the KEKB ring, a two-bunch acceleration scheme has been studied at the linac, in which bunches separated by 96 ns are accelerated in 50 Hz. In this scheme the stabilization of energy and…
The SNS has developed a standard power supply interface for the approximately 350 magnet power supplies in the SNS accumulator ring, Linac and transport lines. Power supply manufacturers are providing supplies compatible with the standard…
The Electron-Ion Collider (EIC) will use swap-out injection scheme for the Electron Storage Ring (ESR) to overcome limitations in polarization lifetime. However, the pursuit of highest luminosity with the required 28 nC electron bunches…
Most of the devices in the SLAC control system are accessed via interface modules in ~450 CAMAC crates. Low-cost controllers in these crates communicate via a SLAC-proprietary bit-serial protocol with 77 satellite control computers…
The electron and positron accelerator complex at KEK offers unique experimental opportunities in the fields of elementary particle physics with SuperKEKB collider and photon science with two light sources. In order to maximize the…
We will use EPICS toolkit [1] to build a prototype for upgrading BEPC control system. The purposes are for the following three aspects: (1) Setup a network based distributed control system with EPICS. (2) Study some front-end control…
Intrabeam scattering (IBS) limits the emittance and single-bunch current that can be achieved in electron or positron storage ring colliders, damping rings, and light sources. Much theoretical work on IBS exists, and while the theories have…
Inverter Based Generators (IBGs) have been increasing significantly in power systems. Due to the demanding thermal rating of Power Electronics (PE), their contribution to the system Short Circuit Current (SCC) is much less than that from…
This work investigates the use of pulse stretching inverters for monitoring the variation of flux and Linear Energy Transfer (LET) of energetic particles. The basic particle detector consists of two cascaded pulse stretching (skew-sized)…
Details on Final design for Cryogenic Electrical & Controls System for Fermilab' s next-gen particle accelerator PIP-II. Electrical Controls System includes instrumentation and controls of Cryogenics Distribution System and Cryomodules.…
Frequency response and voltage support are vital ancillary services for power grids. In this paper, we design and experimentally validate a real-time control framework for battery energy storage systems (BESSs) to provide ancillary services…
The SPring-8 control system provides data acquisition software called Poller/Collector for periodic data taking. Its polling scheme does not support taking data synchronized with an event, and simultaneity in the data from the different VME…
This paper proposes a control method for battery energy storage systems (BESSs) to provide concurrent primary frequency and local voltage regulation services. The actual variable active and reactive power capability of the converter, along…
This paper presents history and evolution of the intra-bunch feedback system for circular accelerators. This pro-ject has been presented by John D. Fox (SLAC/Stanford Un.) at the IPAC2010 held in Kyoto. The idea of the pro-posal is to build…
Fast-response voltage regulation is essential for data-center Voltage Regulation Modules (VRMs) powering Artificial Intelligence (AI) workloads, which exhibit both small-amplitude fluctuations and abrupt full-load steps. This paper…
We introduce a new application of measuring symplectic generators to characterize and control the linear betatron coupling in storage rings. From synchronized and consecutive BPM (Beam Position Monitor) turn-by-turn (TbT) readings,…