Related papers: Distributed Can-Bus Based Beam Diagnostic System f…
A PC based high speed silicon microstrip beam telescope consisting of several independent modules is presented. Every module contains an AC-coupled double sided silicon microstrip sensor and a complete set of analog and digital signal…
A fast-reading current integrator is developed for high time-resolution and low-noise ion beam diagnostics under both continuous-wave and pulsed operating conditions. The system combines a low-leakage transimpedance front-end with a hybrid…
Doubly selective (DS) channel estimation in largescale multiple-input multiple-output (MIMO) systems is a challenging problem due to the requirement of unaffordable pilot overheads and prohibitive complexity. In this paper, we propose a…
The Intense Pulsed Neutron Source has been an operating user facility for more than 20 years. Development of an upgrade for the data acquisition system has been in progress for some time now. Now that the initial installation on the test…
A 70 GeV Proton Synchrotron Extracted Beam Lines Control System is described. About 130 Magnet Dipoles and Quadrupoles, 20 Correction Magnets, 50 Beam Collimators, BPM equipment spread over 1 Km have to be controlled. The old System was…
This paper describes the design and development of low cost USB Data Acquisition System (DAS) for the measurement of physical parameters. Physical parameters such as temperature, humidity, light intensity etc., which are generally slowly…
In this paper, a low-cost monopulse receiver with an enhanced direction of arrival (DoA) estimation accuracy via deep neural network (DNN) is proposed. The entire system is composed of a 4-element patch array, a fully planar symmetrical…
Recent research has highlighted the vulnerability of in-vehicle network protocols such as controller area networks (CAN) and proposed machine learning-based intrusion detection systems (IDSs) as an effective mitigation technique. However,…
In this paper, we describe a modular data acquisition system developed as the foundation of a cosmic ray detector network. Each detector setup (henceforth referred as a station) is composed of an independent hardware device that can be…
In this paper, we design a PXI-based, multi-channel data-acquisition system (DAS) mainly applicable to recording one-shot fast transient pulses in nuclear physics experiments. The system consists of one NI PXIe-1085 chassis, containing a…
The traditional centralized baseband processing architecture is faced with the bottlenecks of high computation complexity and excessive fronthaul communication, especially when the number of antennas at the base station (BS) is large. To…
Data acquisition systems for the accelerator complex at SRRC composed various hardware and software components. Beam signals are processed by related processing electronics, and connect to control system by various type of interfaces in…
Pulse wave analysis is an important method used to gather information about the cardiovascular system. Instead of detecting the pulse wave via pressure sensors, bioimpedance measurements can be performed to acquire minuscule changes in the…
An analog integrated circuit has been designed, in a BiCMOS 0.8 micron technology, for the feasability study of the signal processing of the AMS RICH photomultiplier tubes. This low power, three channel gated integrator includes its own…
To reduce CO2 emissions and tackle increasing fuel costs, the aviation industry is swiftly moving towards the electrification of aircraft. From the viewpoint of systems and control, a key challenge brought by this transition corresponds to…
The DISTO collaboration has built a large-acceptance magnetic spectrometer designed to provide broad kinematic coverage of multi-particle final states produced in $pp$ scattering. The spectrometer has been installed in the polarized proton…
The Controller Area Network (CAN) protocol, essential for automotive embedded systems, lacks inherent security features, making it vulnerable to cyber threats, especially with the rise of autonomous vehicles. Traditional security measures…
The beam diagnostic system of U-70 beam transfer lines (beam profiles, intensity and beam losses measurements) was designed in the beginning of 80-th on the base of 8-bit microprocessor, SUMMA hardware and home made serial communication…
The SRS is a 2GeV synchrotron light source with 14 beamlines serving approximately 34 experimental stations. Control of the major elements of the beamlines (vacuum pumps, gauges, valves and radiation stops) is the responsibility of the main…
Microresonators are essential in integrated photonics, enabling optical filters, modulators, sensors, and frequency converters. Their spectral response is governed by bus-to-resonator coupling, typically classified as under-, critical-, or…