Related papers: Distributed Can-Bus Based Beam Diagnostic System f…
This paper presents a deep unfolding-supported coordinated multipoint beam pattern synthesis (DUCoMP-BPS) scheme to overcome the high complexity, poor adaptability, and limited scalability of traditional cell-free anti-jamming beamforming.…
In this paper, a real-time 105-channel data acquisition platform based on FPGA for imaging will be implemented for mm-wave imaging systems. PC platform is also realized for imaging results monitoring purpose. Mm-wave imaging expands our…
Modern vehicles contain a few controller area networks (CANs), which allow scores of on-board electronic control units (ECUs) to communicate messages critical to vehicle functions and driver safety. CAN provide a lightweight and reliable…
Modern network performance monitoring toolkits, such as perfSONAR, take a remarkable number of measurements about the local network environment. To gain a complete picture of network performance, however, one needs to aggregate data across…
Analysis of video images is a common way to determine the properties of an electron or synchrotron radiation beam. At BESSY a cost-efficient frame grabber hardware controlled by a Windows PC allows one to perform such an analysis in…
We have designed, fabricated and operated a scalable system for applying independently programmable time-independent, and limited time-dependent flux biases to control superconducting devices in an integrated circuit. Here we report on the…
A 128-channel picoammeter system is constructed based on instrumentation amplifiers. Taking the advantages of high electric potential and narrow bandwidth in DC energetic charged beam measurements, current resolution better than 5 fA can be…
Diffusion models (DMs) have become the leading choice for generative tasks across diverse domains. However, their reliance on multiple sequential forward passes significantly limits real-time performance. Previous acceleration methods have…
The widespread diffusion of precision radiotherapy techniques, geared toward the release of larger dose gradients in shorter time frames, is leading to new challenges in dosimetry. Accurate dose measurements are essential to check for beam…
We present the outlines of a new microcontroller based data acquisition system which is aimed for reliable operation in a typical cosmic ray particle registration experiment. The system supports connection of up to 16 input signals and…
In this paper, we present a robust distributed model predictive control (DMPC) scheme for dynamically decoupled nonlinear systems which are subject to state constraints, coupled state constraints and input constraints. In the proposed…
The introduction of complex SoCs with multiple processor cores presents new development challenges, such that development support is now a decisive factor when choosing a System-on-Chip (SoC). The presented developments support strategy…
We present a comprehensive strategy and its practical implementation using the commercial ScanImage software platform to perform hyperspectral point scanning microscopy when a fast time dependent signal varies at each pixel level. In the…
Base station (BS) association and beam selection in multi-cell drone corridor networks present unique challenges due to the high altitude, mobility and three-dimensional movement of drones. These factors lead to frequent handovers and…
The status of R&D activities for CLIC module acquisition are discussed [1]. LAPP is involved in the design of the local CLIC module acquisition crate, described in the document Study of the CLIC Module Front-End Acquisition and Evaluation…
A fully digital beam position and phase measurement (BPPM) system was designed for the linear accelerator (LINAC) in Accelerator Driven Sub-critical System (ADS) in China. Phase information is obtained from the summed signals from four…
The goal of this work is to minimize the energy dissipation of embedded controllers without jeopardizing the quality of control (QoC). Taking advantage of the dynamic voltage scaling (DVS) technology, this paper develops a performance-aware…
One critical value microgrids bring to power systems is resilience, the capability of being able to island from the main grid under certain conditions and connect back when necessary. Once islanded, a microgrid must be synchronized to the…
The Phase-1 upgrade of the CMS pixel detector is built out of four barrel layers (BPix) and three forward disks in each endcap (FPix). It comprises a total of 124M pixel channels in 1,856 modules, and it is designed to withstand…
Data logging at an upgraded KEKB accelerator or the J-PARC facility, currently under commission, requires a high density data acquisition platform with integrated data reduction CPUs. To follow market trends, we have developed a DAQ…