Related papers: High-Power Testing of the APT Power Coupler
The 2014-2015 prediction, discovery, and confirmation of record high temperature superconductivity above 200K in H$_3$S, followed by the 2018 extension to superconductivity in the 250-280K range in lanthanum hydride, marks a new era in the…
The design of a radiation-hard dual channel 12-bit 40 MS/s pipeline ADC with extended dynamic range is presented, for use in the readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider. The…
In the recently commissioned superconducting RF cavity test facility at Fermilab (SCTF), a 325 MHz, {\beta}=0.22 superconducting single-spoke resonator (SSR1) has been tested for the first time with its input power coupler. Previously, this…
A three-cell 1.3 GHz, Normal Conducting (NC) buncher is designed for a possible future upgrade of the European XFEL to operate in a continuous-wave (CW) / long pulse (LP) mode. The RF geometry of the buncher is optimized for high shunt…
The continue wave (CW) high current proton linac has wide applications as the front end of the high power proton machines. The low energy part is the most difficult one and there is no widely accepted solution yet. Based on the analysis of…
We report on the coherent reflection spectroscopy of a high-quality factor micropillar, in the strong coupling regime with a single InGaAs annealed quantum dot. The absolute reflectivity measurement is used to study the characteristics of…
The ruggedness of HBT Class-C power amplifiers was improved by adding an anti-parallel diode to the amplifier input to limit the negative swing of the base-emitter voltage. The improved amplifier could withstand 3:1 instead of 2:1 mismatch…
Reducing the operating temperature of normal conducting particle accelerators substantially increases their efficiency. Low-temperature operation increases the yield strength of the accelerator material and reduces surface resistance, hence…
A recent experiment has reported a nitrogen-doped lutetium hydride acheving a remarkable Tc of 294 K at just 1 GPa, significantly reducing the required pressure for obtaining room temperature superconductivity. However, subsequent…
A grating coupler on 700-nm-thick Z-cut lithium-niobate-on-insulator platform with high coupling efficiency, large bandwidth, and high fabrication tolerance is designed and optimized by inverse design method. The optimized grating coupler…
We present the measurement of the production cross section for top quark pair ($t\bar{t}$) in pp collisions at $\sqrt{s}$ = 7 TeV using the data recorded with the ATLAS detector at the Large Hadron Collider (LHC). Events are selected in…
The development of high gradient accelerating structures is one of the leading activities of the accelerator community. In the technological research of new construction methods for these devices, high-power testing is a critical step for…
In high-performance RF transceivers the thrust of has been on lower noise LNAs and high-power high-speed PAs. The performance trade-off has forced many solutions to have the LNA and PA on a separate die compared to the rest of baseband.…
Using numerical simulations, we show that two coupled qubits can amplify a weak signal about hundredfold. This can be achieved if the two qubits are biased simultaneously by this weak signal and a strong pump signal, both of which having…
The Wireless Allowing Data and Power Transmission (WADAPT) proposal was formed to study the feasibility of wireless technologies in HEP experiments. A strong motivation for using wireless data transmission at the ATLAS detector is the…
The quest for room-temperature superconductors has been teasing scientists and physicists, since its inception in 1911 itself. Several assertions have already been made about room temperature superconductivity but were never verified or…
Superconducting radio-frequency cavities are commonly used in modern particle accelerators for applied and fundamental research. Such cavities are typically made of high-purity, bulk Nb and are cooled by a liquid helium bath at a…
Cavity combiners have been put forward for high power combining due to their advantages of larger combining ability, variable input channels and less power loss. For a high power cavity combiner, it is better to keep the power loss ratio in…
We are currently operating the front end of the accelerator production of tritium (APT) accelerator, a 7 MeV radio frequency quadrapole (RFQ) using three, 1.2 MW CW klystrons. These klystrons are required and designed to dissipate the full…
We study the sensitivity of the Large Hadron Collider (LHC) to anomalous tbW couplings in single-top production in association with a W^- boson followed by semileptonic decay of the top. We calculate top polarization and the effects of…