Related papers: Alignment procedure for the VIRGO Interferometer: …
We present a frequency modulation technique for calibration of the displacement actuators of the LIGO 4-km-long interferometric gravitational-wave detectors. With the interferometer locked in a single-arm configuration, we modulate the…
The Laser Interferometer Space Antenna (LISA) is a future space-based interferometric gravitational-wave detector consisting of three spacecraft in a triangular configuration. The interferometric measurements of path length changes between…
An experimental technique is developed to simultaneously measure both temporal and spatial coherences of a light source by altering a standard Michelson interferometer, which has been primarily used for measuring temporal coherence only.…
Aligning a microcantilever to an area of interest on a sample is a critical step in many scanning probe microscopy experiments, particularly those carried out on devices and rare, precious samples. We report a series of protocols that…
This article presents a novel type of very long baseline astronomical interferometer that uses the fluctuations, as a function of time, of the intensity measured by a quadratic detector, which is a common type of astronomical detector. The…
This paper deals with the reconstruction of the direction of a gravitational wave source using the detection made by a network of interferometric detectors, mainly the LIGO and Virgo detectors. We suppose that an event has been seen in…
It is shown that atom interferometry allows for the construction of MIGO, the Matter-wave Interferometric Gravitational-wave Observatory. MIGOs of the same sensitivity as LIGO or LISA are expected to be orders of magnitude smaller than…
We present a Michelson-type microwave interferometer for use in ferromagnetic resonance experiments. The interferometer is capable of broadband operation without manual adjustment of phase delay or amplitude attenuation. A prototype of the…
We discuss optimal strategy for follow-up observations by 1-3 m class optical/infrared telescopes which target optical/infrared counterparts of gravitational wave events detected with two laser interferometric gravitational wave detectors.…
Several large-scale interferometric gravitational-wave detectors use resonant arm cavities to enhance the light power in the interferometer arms. These cavities are based on different optical designs: One design uses wedged input mirrors to…
Precision measurements are reported of the cross-spectrum of rotationally-induced differential position displacements in a pair of colocated 39 m long, high power Michelson interferometers. One arm of each interferometer is bent…
The paper proposes a novel calibration approach for the Orthoglide-type mechanisms based on observations of the manipulator leg parallelism during motions between the prespecified test postures. It employs a low-cost measuring system…
We propose a compact MEMS-based optical autocorrelator based on a micromachined Michelson interferometer in silicon and the two-photon absorption non-linearity in a photodetector. The miniaturized autocorrelator has a scanning range of 1.2…
We present an analytical description and an experimental realization of interscale mixing microscopy, a diffraction-based imaging technique that is capable of detecting wavelength/10 objects in far-field measurements with both coherent and…
In the quest to develop viable designs for third-generation optical interferometric gravitational-wave detectors (e.g., LIGO-III and EURO), one strategy is to monitor the relative momentum or speed of the test-mass mirrors, rather than…
Advanced LIGO and Virgo have so far detected gravitational waves from 10 binary black hole mergers (BBH) and 1 binary neutron star merger (BNS). In the future, we expect the detection of many more marginal sources, since compact binary…
This document records the results of a comparison of the interferometer simulation Finesse against an analytic (MATLAB based) calculation of the alignment sensing signals of a Fabry Perot cavity. This task was started during the…
This paper proposes a simple self-calibration method for the internal time synchronization of MEMS(Micro-electromechanical systems) LiDAR during research and development. Firstly, we introduced the problem of internal time misalignment in…
We analyze the sensitivity of a network of interferometer gravitational-wave detectors to the gravitational-wave stochastic background, and derive the dependence of this sensitivity on the orientations of the detector arms. We build on and…
We propose a novel x-ray imaging system, Multi-Image X-ray Interferometer Module (MIXIM), with which a very high angular resolution can be achieved even with a small system size. MIXIM is composed of equally-spaced multiple slits and an…