Related papers: Alignment procedure for the VIRGO Interferometer: …
The French-Italian interferometric gravitational wave detector VIRGO is currently being commissioned. Its principal instrument is a Michelson laser interferometer with 3 km long optical cavities in the arms and a power-recycling mirror. The…
The French-Italian interferometric gravitational wave detector VIRGO is currently being commissioned. Its principal instrument is a Michelson interferometer with 3 km long optical cavities in the arms and a power-recycling mirror. This…
Virgo is a kilometer-length interferometer for gravitational waves detection located near Pisa. Its first science run, VSR1, occured from May to October 2007. The aims of the calibration are to measure the detector sensitivity and to…
The Virgo detector is a kilometer-length interferometer for gravitational wave detection located near Pisa (Italy). During its second science run (VSR2) in 2009, six months of data were accumulated with a sensitivity close to its design. In…
We report on the active stabilization of a Michelson interferometer at an arbitrary phase angle with a precision better than one degree at $\lambda = 632.8$ nm, which corresponds to an optical path difference between the two arms of less…
We report on the measurements of tilt noise performed at the Virgo site with a ring laser gyroscope. The apparatus is a He-Ne laser operating in a square cavity mounted on a vertical plane perpendicular to the north-south arm of the…
In order to achieve full detection sensitivity at low frequencies, the mirrors of interferometric gravitational wave detectors must be isolated from seismic noise. The VIRGO vibration isolator, called 'superattenuator', is fully effective…
The Virgo gravitational wave detector is an interferometer (ITF) with 3km arms located in Pisa, Italy. From July to October 2010, Virgo performed its third science run (VSR3) in coincidence with the LIGO detectors. Despite several…
Currently operating gravitational-wave interferometers are Michelson interferometers with effective arm length L ~ 4x10e5 m. While the interferometer remains in lock, data at the fsr sideband frequency encode information on slow phase…
As part of the second phase of Advanced Virgo upgrade program, instrumented baffles are being constructed to be installed around the end mirrors in the main arms, in continuation of what has been implemented for the input mode cleaner end…
The sensitivity of high-precision interferometric measurements can be limited by Brownian noise within dielectric mirror coatings. This occurs, for instance, in the optical resonators of gravitational wave detectors where the noise can be…
With significantly improved sensitivity, the Einstein Telescope (ET), along with other upcoming gravitational wave detectors, will mark the beginning of precision gravitational wave astronomy. However, the pursuit of surpassing current…
We are contructing an interferometric telescope, the Very Small Array, to study the cosmic microwave background on angular scales 0.2--4.5 degrees. The physical layout and electronic design of the telescope are optimised to give maximum…
As the sensitivities of LIGO, Virgo and KAGRA detectors improve, calibration of the interferometers output is becoming more and more important and may impact scientific results. For the observing run O3, Virgo used for the first time photon…
Optical rigidity in aLIGO gravitational-wave detector, operated on dark port regime, is unstable. We show that the same interferometer with excluded symmetric mechanical mode but with unbalanced arms allows to get stable optical spring for…
PASCO scientific 012-05187C Precision Interferometer is used in Michelson mode to investigate wavelengths and refractive indices. From varying the distance of the movable mirror in the Michelson setup the wavelength of the HeNe laser beam…
The Virgo detector is a kilometer-scale interferometer for gravitational wave detection located near Pisa (Italy). About 13 months of data were accumulated during four science runs (VSR1, VSR2, VSR3 and VSR4) between May 2007 and September…
We present an interferometric technique for measuring ultra-small tilts. The information of a tilt in one of the mirrors of a modified Sagnac interferometer is carried by the phase difference between the counter propagating laser beams.…
We measure the motional fluctuations of a micromechanical mirror using a Michelson interferometer, and demonstrate its interferometric stability. The position stability of the micromirror is dominated by the thermal mechanical noise of the…
Aspera is a NASA Astrophysics Pioneers SmallSat mission designed to study diffuse OVI emission from the warm-hot phase gas in the halos of nearby galaxies. Its payload consists of two identical Rowland Circle-type long-slit spectrographs,…