Related papers: High performance hard magnetic NdFeB thick films f…
Thin films of Ti1-xCoxO2 (x=0 and 0.03) have been prepared on sapphire substrates by spin-on technique starting from metalorganic precursors. When heat treated in air at 550 and 700 C respectively, these films present pure anatase and…
Superconducting Nb3Sn films can be synthesized by controlling the atomic concentration of Sn. Multilayer sequential sputtering of Nb and Sn thin films followed by high temperature annealing is considered as a method to fabricate Nb3Sn…
Manganese silicide (MnxSiy) thin films with Mn content (CMn) varied from 24 at. % to 52 at. % were grown on i-GaAs (100) substrates. Chemical, phase composition and room temperature magnetic properties of the films were investigated. It was…
Room temperature ferromagnetic semiconductor rutile Ti1-xCoxO2-\delta (101) epitaxial thin films were grown on r-sapphire substrates by a dc sputtering method. Ferromagnetic magnetization, magnetic circular dichroism, and anomalous Hall…
A series of Co_xCu_{100-x} (x = 0, 40...75, 100) layers with thicknesses in-between 13 nm and 55 nm were prepared on silicon substrates using cross-beam pulsed laser deposition. Wide-angle X-ray diffraction (WAXRD), transmission electron…
In the present work, a thin film was deposited on quartz substrate by reactive RF magnetron sputtering of high purity (99.999%) aluminium target using ultra-high pure (Ar + N2) gas mixture. The percentage ratio of Ar and N2 in the gas…
Thin films of TbMnO3 have been grown on SrTiO3 substrates. The films grow under compressive strain and are only partially clamped to the substrate. This produces remarkable changes in the magnetic properties and, unlike the bulk material,…
Superconducting MgB2 thin films were fabricated on Al2O3(0001) substrates under an ex-situ processing conditions. Boron thin films were deposited by pulsed laser deposition followed by a post-annealing process. Resistance measurements of…
Epitaxial films have the potential to be used as model systems for fundamental investigations on the martensitic transformation in binary NiTi. In this paper, we discuss growth of binary NiTi thin films on single crystalline MgO substrates.…
We report the growth of high-quality c-axis-oriented epitaxial MgB2 thin films by using a pulsed laser deposition technique. The thin films grown on (1`1 0 2) Al2O3 substrates show a Tc of 39 K. The critical current density in zero field is…
Epitaxial thin films of La0.7Ba0.3MnO3 manganite, deposited using Chemical Solution Deposition technique, were irradiated by 200 MeV Ag+15 ions with a maximum ion dose up to 1x10^12 ions/cm2. Temperature- and magnetic field-dependent…
We have investigated properties of superconducting titanium nitride (TiN) films that were sputtered over a large range of RF-induced DC bias voltage applied to the substrate. Films grown with the largest bias voltages contained cubic TiN…
A set of thin film Mn$_x$Si$_{1-x}$ alloy samples with different manganese concentration x = 0.44 - 0.63 grown by the pulsed laser deposition (PLD) method onto the Al$_2$O$_3$(0001) substrate was investigated in the temperature range 4 -…
a-Nb(x)Si(1-x) thin films with thicknesses down to 25 {\AA} have been structurally characterized by TEM (Transmission Electron Microscopy) measurements. As-deposited or annealed films are shown to be continuous and homogeneous in…
Investigations into the magnetic properties of sputtered Mn$_{x}$CoGe films in the range $0.8 \leq x \leq 2.5$ uncovered ferrimagnetic order, unlike the ferromagnetic order reported in bulk samples. These films formed hexagonal…
The crystallization process and the magnetization of Cr diluted CoFeB was investigated in both ribbon samples and thin film samples with Cr content up to 30 at. %. A primary crystallization of bcc phase from an amorphous precursor in ribbon…
Exploring new topological materials with large topological nontrivial bandgaps and simple composition is attractive for both theoretical investigation and experimental realization. Recently alpha tin ({\alpha}-Sn) has been predicted to be…
Magnetic isotropic NdFeB powder is processed by the following additive manufacturing methods: (i) stereolithography (SLA), (ii) fused filament fabrication (FFF), and (iii) selective laser sintering (SLS). For the first time, a…
Stabilized FeSe thin films in ambient pressure with tunable superconductivity would be a promising candidate for superconducting electronic devices yet its superconducting transition temperature (Tc) is below 10 K in bulk materials. By…
The effects of strain on a film of mulitferroic GdMnO3 are investigated using both magnetometry and magneto-optic spectroscopy. Optical spectra, in the energy range 1.5eV - 3.5eV, were taken in Faraday geometry in an applied magnetic field…