Related papers: Improved critical current densities in MgB2 tapes …

We optimized the substrate temperature (Ts) and phosphorus concentration (x) of BaFe2(As1-xPx)2 films on practical metal-tape substrates for pulsed laser deposition from the viewpoints of crystallinity, superconductor critical temperature…

Unlike the widely studied $s$-type two-gap superconductor MgB$_2$, the chemically similar compounds ZrB$_2$ and HfB$_2$ do not superconduct above 1 K. Yet, it has been shown that small amounts of self- or extrinsic doping (in particular…

Investigations of MgB2 and Fe-based superconductors in recent years have revealed many unusual effects of multiband superconductivity but manifestations of anisotropic multiband effects in the critical current density Jc have not been…

High-quality FeSe tapes have been prepared by using a diffusion method. By adjusting the reaction temperature and the thickness systematically, a transport critical current density as high as 600 A/cm2 at 4.2 K under self field is achieved.…

We present details of synthesis optimization and physical properties of nearly single phase carbon doped MgB2 with a nominal stoichiometry of Mg(B{0.8}C{0.2})2 synthesized from magnesium and boron carbide (B4C) as starting materials. The…

The doping dependence of the critical current density, $J_{c}$, was measured in a series of high quality c-axis oriented ${\rm Bi_2Sr_2CaCu_2O_{8+\delta}}$ thin films. For each doping level we measured the temperature dependence of $J_{c}$.…

The MgB2 superconductor was doped with electroluminescent Y2O3:Eu, to synthesise a superconducting metamaterial. The temperature dependence of the resistivity of the superconductor indicates that the critical temperature (TC) of samples…

We report on the results of a comparative investigation of highly dense bulk MgB$_2$ samples prepared by three methods: (i) hot deformation; (ii) high pressure sintering; and (iii) mechanical alloying of Mg and B powders with subsequent hot…

We demonstrate that 3.5-MeV oxygen irradiation can markedly enhance the in-field critical current of commercial 2nd generation superconducting tapes with an exposure time of just one second per 0.8 cm2. The speed demonstrated here is now at…

This review paper illustrates the main normal and superconducting state properties of magnesium diboride, a material known since early 1950's, but recently discovered to be superconductive at a remarkably high critical temperature Tc=40K…

An important predicted, but so far uncharacterized, property of the new superconductor MgB2 is electronic anisotropy arising from its layered crystal structure. Here we report on three c-axis oriented thin films, showing that the upper…

Bulk samples of MgB2 have been formed by hot isostatic pressing (HIPping) of commercial powder at 100MPa and 950=B0C. The resulting material is 100% dense with a sharp superconducting transition at 37.5K. Microstructural studies have…

Magnesium diboride superconducting wires give the largest critical current density (Jc) when produced with iron sheath. Because iron is ferromagnetic, it is expected to improve the field dependence of Jc by shielding of the external field…

We report on transport and magnetization measurements of the critical current density Jc in ErNi2B2C single crystals that show strongly enhanced vortex pinning at the Neel temperature TN and low applied fields. The height of the observed Jc…

We report the effect of adipic acid (C6H10O4) doping on lattice parameters, microstructure, critical temperature (Tc), current density (Jc), and irreversibility field (Hirr) for MgB2 superconductor. Actual carbon (C) substitution level for…

We report the influence of crystalline defects introduced by 6 MeV $^{16}$O$^{3+}$ irradiation on the critical current densities J$_c$ and flux creep rates in 1.3 $\mu$m thick GdBa$_2$Cu$_3$O$_{7-d}$ coated conductor produced by…

Incorporating with inhomogeneous phases with high electroluminescence (EL) intensity to prepare smart meta-superconductors (SMSCs) is an effective method of increasing the superconducting transition temperature (Tc) and has been confirmed…

MgB2-diamond nanocomposite superconductors have been synthesized by addition of nano-diamond powder. Microstructural analysis shows that the nanocomposite superconductor consists of tightly-packed MgB2 nano-grains (~50-100 nm) with…

We report the fabrication of small (Ba,A)Fe2As2 (A: Na, K) coils using 10 m-class long round wires, fabricated by powder-in-tube (PIT) method. Coils are sintered using hot-isostatic-press (HIP) technique after glass-fiber insulations are…

If the critical current density Jc is very high for a superconductor, then estimating its value from transport measurements is not very easy. In such cases, the value of Jc, called Jcm for magnetic Jc, is usually obtained from the measured…