Related papers: Forced dewetting on porous media
We numerically investigate crystalline order on negative Gaussian curvature capillary bridges. In agreement with the experimental results in [W. Irvine et al., Nature, "Pleats in crystals on curved surfaces", 2010, (468), 947]} we observe…
Understanding how water wets graphene is critical for predicting and controlling its behaviour in nanofluidic, sensing, and energy applications. A key measure of wetting is the contact angle made by a liquid droplet against the surface, yet…
We propose a sharp-interface model for solid-state dewetting of thin films with wetting potential, where the wetting effect is incorporated through a thickness-dependent surface energy. The model is governed by surface diffusion together…
We study minimal surfaces which arise in wetting and capillarity phenomena. Using conformal coordinates, we reduce the problem to a set of coupled boundary equations for the contact line of the fluid surface, and then derive simple…
The conventional no-slip boundary condition leads to a non-integrable stress singularity at a contact line. This is a main challenge in numerical simulations of two-phase flows with moving contact lines. We derive a two-dimensional…
The dynamics of a rigid particle above a fluid-fluid interface in shear flow is studied here numerically and analytically as a function of the downward force applied on the particle. It is found here that the particle goes below the…
We theoretically investigate the apparent contact angle of droplets on liquid infused surfaces as a function of the relative size of the wetting ridge and the deposited droplet. We provide an intuitive geometrical interpretation whereby the…
Capillary jetting of a fluid dispersed into another immiscible phase is usually limited by a critical Capillary number, a function of the Reynolds number and the fluid properties ratios. Critical conditions are set when the minimum…
The dip-coating geometry, where a solid plate is withdrawn from or plunged into a liquid pool, offers a prototypical example of wetting flows involving contact-line motion. Such flows are commonly studied using the lubrication approximation…
We study the deformation of soft solid layers in the presence of sessile droplets or capillary bridges. By incorporating the surface tension balance at the contact line, we examine the rotation of the wetting ridge and the corresponding…
As was shown in an earlier paper [1], solids dispersed in a drying drop migrate to the (pinned) contact line. This migration is caused by outward flows driven by the loss of the solvent due to evaporation and by geometrical constraint that…
We use boundary-integral methods to compute the time-dependent deformation of a drop of dielectric fluid immersed in another dielectric fluid in a uniform electric field E. Steady state theory predicts, when the permittivity ratio, \beta,…
Differential geometry is powerful tool to analyze the vapor-liquid critical point on the surface of the thermodynamic equation of state. The existence of usual condition of the critical point $\left( \partial p/\partial V\right) _{T}=0$…
Recently contact angle hysteresis in two-dimensional droplets lying on a solid surface has been studied extensively in terms of static friction due to pinning forces at contact points. Here we propose a method to determine the coefficient…
Electrical conductivity is one of the most commonly used geophysical method for reservoir and environmental studies. Its main interest lies in its sensitivity to key properties of storage and transport in porous media. Its quantitative use…
The influence of geometrical parameters and fluid properties on the critical pressure of permeation of an oil micro-droplet into a slotted pore is studied numerically by solving the Navier-Stokes equations. We consider a long slotted pore,…
When a Coulombic fluid is confined between two parallel charged plates, an exact relation links the difference of ionic densities at contact with the plates, to the surface charges of these boundaries. It no longer applies when the…
Controlling the shape and position of moving and pinned droplets on a solid surface is an important feature often found in microfluidic applications. However, automating them, e.g., for high-throughput applications, does rarely involve…
The dynamics of particles attached to an interface separating two immiscible fluids are encountered in a wide variety of applications. Here we present a combined asymptotic and numerical investigation of the fluid motion past spherical…
The open water surface is known to be charged. Yet, the magnitude of the charge and the physical mechanism of the charging remain unclear, causing heated debates across the scientific community. Here we directly measure the charge Q of…