Related papers: Mixing with the radiofrequency single-electron tra…
Microelectromechanical system (MEMS) based on-chip resonators offer great potential for high frequency signal processing circuits like reference oscillators and filters. This is due to their exceptional features like small size, large…
Mixing in an active micromixer was achieved using Lorentz force-assisted actuation of an enameled copper wire. A single-step template-assisted soft lithography technique was used to construct the mixing chamber. The chamber had a volume of…
The wide bandwidth and large number of antennas used in millimeter wave systems put a heavy burden on the power consumption at the receiver. In this paper, using an additive quantization noise model, the effect of analog-digital conversion…
We perform in-situ detection of individual electrons pumped through a single-electron turnstile based on ultrasmall normal metal - insulator - superconductor tunnel junctions. In our setup, limited by the detector bandwidth, at low…
Realizing capacity demands of future wireless communications requires improved spectral efficiency in the sub-6-GHz frequency bands. This paper proposes a novel eight-element multiple-input multiple-output (MIMO) antenna that can be tuned…
We fabricated and tested the single electron R-pump, i.e. a three-junction Al circuit with on-chip Cr resistors. We show that due to the presence of the resistors (R > h/e^2 = 25.8 kOhm), the accuracy of electron transfer in the R-pump can…
We report on a traceable calibration system for a 3500mm-long console that carries a measurement system for inspecting the diameter of a circular reactor chassis. The system uses two single-pass laser interferometers with homodyne fringe…
A whole class of two-color experiments involves intense, short Terahertz radiation pulses. A fast detector that is sensitive and able to resolve both near-infrared and Terahertz pulses at the same time is highly desirable. Here we present…
Optical frequency-comb-based-high-resolution spectrometers offer enormous potential for spectroscopic applications. Although various implementations have been demonstrated, the lack of suitable mid-infrared comb sources has impeded…
The measurement of a superconducting qubit is implemented by coupling it to a resonator. The common choice is transverse coupling, which, in the dispersive approximation, introduces an interaction term which enables the measurement. This…
In this work, a microwave photonic prototype for concurrent radar detection and spectrum sensing is proposed, designed, built, and investigated. A direct digital synthesizer and an analog electronic circuit are integrated to generate an…
We analyze theoretically the properties of the recently introduced and experimentally demonstrated converter of frequency to power. The system is composed of a hybrid single-electron box with normal island and superconducting lead, and the…
We report high-bandwidth charge sensing measurements using a GaAs quantum point contact embedded in a radio frequency impedance matching circuit (rf-QPC). With the rf-QPC biased near pinch-off where it is most sensitive to charge, we…
The single electron transistor (SET) offers unparalled opportunities as a nano-scale electrometer, capable of measuring sub-electron charge variations. SETs have been proposed for read-out schema in solid-state quantum computing where…
Dispersive Fourier transformation is a powerful technique in which spectral information is mapped into the time domain using chromatic dispersion. It replaces a spectrometer with an electronic digitizer, and enables real-time spectroscopy.…
We have upgraded the 60-cm radio survey telescope located in Nobeyama, Japan. We developed a new waveguide-type sideband-separating SIS mixer for the telescope, which enables the simultaneous detection of distinct molecular emission lines…
We present experimental data on a one-dimensional superconducting metamaterial that is tunable over a broad frequency band. The basic building block of this magnetic thin-film medium is a single-junction (rf-) superconducting quantum…
A 25-40GHz passive mixer-first receiver using a novel architecture for digital beamforming arrays is proposed. The architecture uses a novel technique for impedance matching using the on-resistance of the mixers in the receiver and matching…
Achieving high bit rates is the main goal of wireless technologies like 5G and beyond. This translates to obtaining high spectral efficiencies using large number of antennas at the transmitter and receiver (single user massive multiple…
We have operated a quantum point contact (QPC) charge detector in a radio frequency (RF) mode that allows fast charge detection in a bandwidth of tens of megahertz. We find that the charge sensitivity of the RF-QPC is limited not by the…