Related papers: AC-Calorimetry at High Pressure and Low Temperatur…
Recent advances regarding the interplay between ab initio calculations and metrology are reviewed, with particular emphasis on gas-based techniques used for temperature and pressure measurements. Since roughly 2010, several thermophysical…
We present the application of a fast quasi-adiabatic continuous method to the measurement of specific heat at 4He temperatures, which can be used for the study of a wide range of materials. The technique can be performed in the same…
We developed a metallic pressure cell made of nickel-chromium-aluminum (NiCrAl) for use with a non-destructive pulse magnet and a magnetic susceptibility measurement apparatus with a proximity detector oscillator (PDO) in pulsed magnetic…
Semiconductor tunable barrier single-electron pumps can produce output current of hundreds of picoamperes at sub ppm precision, approaching the metrological requirement for the direct implementation of the current standard. Here, we operate…
We developed a soft and high thermal conductive heat link for cryogenic applications. The measured maximum thermal conductivity was approximately 18500 W/m/K at 10 K. This spring constant was 1/43 of that of a single thick wire with the…
In recent years there has been considerable interest in developing photonic temperature sensors such as the Fiber Bragg gratings (FBG) as an alternative to resistance thermometry. In this study we examine the thermal response of FBGs over…
Gas pressure sensors based on nanomechanical membranes have recently demonstrated an ultra-wide ten-decade measurement range, a gas-type-independent response, and a self-calibrating operation with uncertainties of approximately $1\,\%$. The…
Elemental materials provide clean and fundamental platforms for studying superconductivity. However, the highest superconducting critical temperature (Tc) yet observed in elements has not exceeded 30 K. Discovering elemental superconductors…
Coulomb blockade thermometers (CBTs) are versatile and, in principle, primary thermometers operating down to the micro-Kelvin range but bias heating spoils the thermometry and the primary mode. Here, we introduce a method to extract the CBT…
Materials with high thermal conductivity are needed to conduct heat away from hot spots in high power electronics and optoelectronic devices. Cubic boron arsenide (c-BAs) has a high thermal conductivity due to its special phonon dispersion…
An experimental proposal to test the existence of a liquid-liquid critical point in water, based on high pressure calorimetric measurements, is presented on this paper. Considering the existence of an intramolecular correlation in the water…
We have carried out high pressure experiment on the pressure-induced superconductor CeIrSi$_3$ without inversion center. The electrical resistivity and ac heat capacity were measured in the same run for the same sample. The critical…
As the simplest element in nature, unraveling the phase diagram of hydrogen is a primary task for condensed matter physics. As conjectured many decades ago, in the low-temperature and high-pressure part of the phase diagram, solid hydrogen…
Ramp compression experiments characterize high-pressure states of matter at temperatures well below those present in shock compression. However, because temperature is typically not directly measured during ramp compression, it is uncertain…
Thermal transpiration effects are commonly encountered in low pressure measurements with capacitance diaphragm gauges. They arise from the temperature difference between the measurement volume and the temperature stabilised manometer.…
Temperature variations of the heat capacity (C) are studied in a low temperature regime for 2D-, and 3D-systems with N~100-10000 treated as a canonical ensemble of N-noninteracting fermions. The analysis of C is performed by introducing…
We report high pressure magnetic susceptibility and electrical resistivity measurements on Ca_{3}Ir_{4}Sn_{13} single crystals up to 60 kbar. These measurements allow us to follow the evolution of the superconducting critical temperature…
A new method for measuring the electron temperature of the plasma in GOL-NB facility is proposed. The proposed method is based on measuring the ratio of intensities of spectral lines emitted by fast atoms injected into the plasma. The beams…
In nuclear, particle and astroparticle physics experiments, calorimeters are used to measure the properties of particles with kinetic energies that range from a fraction of 1 eV to 10^20 eV or more. These properties are not necessarily…
A new set-up to measure acoustic wave velocities through deforming rock samples at high pressures (up to 1000 MPa), temperatures (up to 700$^\circ$C) and differential stress (up to 1500 MPa) has been developed in a recently refurbished gas…