Related papers: Bulk Magnesium Diboride, Mechanical and Supercondu…
Magnesium diboride (MgB2) thin films are a potential alternative to low-temperature superconductors (LTS) due to a higher critical temperature (Tc) of approximately 39 K. The reactive evaporation deposition technique also affords relatively…
Recently it was discovered that, under elevated pressures, MoB$_2$ exhibits superconductivity at a critical temperature, $T_c$, as high as 32 K. The superconductivity appears to develop following a pressure-induced structural transition…
MgB2 thick film was synthesized on the stainless steel substrate by the technique of hybrid physical-chemical vapor deposition (HPCVD), using Mg ingot and B2H6 as the raw materials. The film thickness is about 10 microns. The scanning…
Bulk single crystals of manganese phosphide (MnP) were grown from melt at 1 GPa and 1200 C by using a cubic-anvil, high-pressure, and high-temperature technique. The obtained black colored crystals exhibit a plate-like morphology, with flat…
We developed a micromagnetic method for modeling magnetic systems with periodic boundary conditions along an arbitrary number of dimensions. The main feature is an adaptation of the Ewald summation technique for evaluation of long-range…
In this article, a detailed study of the recently synthesized MAX phase borides M2SB (M = Zr, Hf and Nb) has been performed via first principles technique. Investigation of mechanical hardness, elastic anisotropy, optical properties,…
The structure and physical properties of the Zr-stabilized, nonstoichiometric molybdenum diboride superconductor are reported. Good quality material of the diboride structure type can only be obtained by partial substitution of Zr for Mo,…
We performed ac-susceptibility measurements of magnesium diboride powder samples under pure hydrostatic pressures up to 0.4 GPa and under quasi-hydrostatic pressure conditions up to 8 GPa in a helium gas pressure cell and a diamond-anvil…
Magnesium diboride has many intriguing characteristics, including its relatively high critical temperature and two-band nature. Most prior studies of MgB2 thin film Josephson junctions have been conducted above 2 Kelvin. We report results…
A novel medium Mn steel of composition Fe-12Mn-4.8Al-2Si-0.32C-0.3V was manufactured with 1.09 GPa yield strength, 1.26 GPa tensile strength and 54% elongation. The thermomechanical process route was designed to be industrially translatable…
An ultrafine grained magnesium alloy has been produced through room temperature high-pressure torsion (HPT) of solutionised Mg-1.35 wt.%Mn. Dynamic precipitation of nanometer-scale Mn particles occurred during deformation. These particles…
Superconducting MgB2 thin films were prepared on 50-micrometer-thick, flexible polyamide Kapton-E foils by vacuum co-deposition of Mg and B precursors with nominal thickness of about 100 nm and a special ex-situ rapid annealing process in…
The orthorhombic phase of Si-doped Fe carbide is synthesized at high pressures and temperatures using laser-heated diamond anvil cell (LHDAC), followed by its characterization using X-ray diffraction (XRD) measurements, Transmission…
Powdered and sintered MgB2 samples have been characterized through magnetic measurements performed from T = 5 K up to few degrees above the transition temperature of about 39 K. We found that the sintered samples behave as well-connected…
Interconnect materials with ultralow dielectric constant, and good thermal and mechanical properties are crucial for the further miniaturization of electronic devices. Recently, it has been demonstrated that ultrathin amorphous boron…
There are many fields where it is of interest to measure the elastic moduli of tiny fragile fibers, such as filamentous bacteria, actin filaments, DNA, carbon nanotubes, and functional microfibers. The elastic modulus is typically deduced…
In this paper we show how reliable measurements on porous ceramic films can be made by appropriate nanoindentation experiments and analysis. Room-temperature mechanical properties of the mixed-conducting perovskite material LSCF6428 were…
Microstructural features and mechanical properties of an Al-Mg-Si alloy processed by high-pressure torsion have been investigated using transmission electron microscopy, X-ray diffraction, three-dimensional atom probe, tensile tests and…
LSCF is a promising candidate for the cathode in SOFCs. Understanding the microstructural characteristics is crucial to its application because they predominately determine the performance and durability of the porous cathodes and hence of…
Superconducting MgB(2) films with Tc = 38.6 K were prepared using a precursor-deposition, ex-situ post-processing approach. Precursor films of boron, ~0.5 micrometer thick, were deposited onto Al(2)O(3) (102) substrates by e-beam…