Related papers: Pulling Knotted Polymers
We use complete enumeration and Monte Carlo techniques to study two-dimensional self-avoiding polymer chains with quenched ``charges'' $\pm 1$. The interaction of charges at neighboring lattice sites is described by $q_i q_j$. We find that…
Based upon kinetic Monte Carlo simulations of crystallization in a simple polymer model we present a new picture of the mechanism by which the thickness of lamellar polymer crystals is constrained to a value close to the minimum…
We study jamming in model freely rotating polymers as a function of chain length $N$ and bond angle $\theta_0$. The volume fraction at jamming, $\phi_J(\theta_0)$, is minimal for rigid-rod-like chains ($\theta_0 = 0$), and increases…
Equilibration of polymer melts containing highly entangled long polymer chains in confinement or with free surfaces is a challenge for computer simulations. We approach this problem by first studying polymer melts based on the soft-sphere…
Monte Carlo simulations are used to study the translocation of a polymer into a cavity. Modeling the polymer as a hard-sphere chain with a length up to N=601 monomers, we use a multiple-histogram method to measure the variation of the…
This paper reports the force spectroscopy analysis of a polymer that translocates from one side of a membrane to the other side through an extended pore, pulled by a cantilever that moves with constant velocity against the damping and the…
Drawing an analogy to the paradigm of quasi-elastic neutron scattering, we present a general approach for quantitatively investigating the spatiotemporal dependence of structural anisotropy relaxation in deformed polymers by using…
We investigate polymer translocation through a nanopore under a pulling force using Langevin dynamics simulations. We concentrate on the influence of the chain length $N$ and the pulling force $F$ on the translocation time $\tau$. The…
We study polymers attached to spherical (circular) or paraboloidal (parabolic) probes in three (two) dimensions. Both self-avoiding and random walks are examined numerically. The behavior of a polymer of size $R_0$ attached to the tip of a…
The molecular dynamics simulations were used to obtain the radius of gyration of real ring polymer chains with different topological structures consisting of 360 monomers. We focus on the entropic force which is exerted by a dilute solution…
We investigate by Monte Carlo simulations the zipping and unzipping dynamics of two polymers connected by one end and subject to an attractive interaction between complementary monomers. In zipping, the polymers are quenched from a high…
Herein, we describe new methods to produce colloidal particle chains of three stiffness regimes that can be observed on a single-particle level, that is, on the level of the monomers that make up the chain; the chains can even be observed…
The bond fluctuation method is used to simulate both non-concatenated entangled and interpenetrating melts of ring polymers. We find that the swelling of interpenetrating rings upon dilution follows the same laws as for linear chains.…
In this study, we have utilized a molecular dynamics simulation approach to understand adhesion and friction behaviour of crosslinked polymer networks. We have used breakable quartic bond to model crosslinked polymers. We explored the…
The depletion interaction between two parallel repulsive walls confining a dilute solution of long and flexible polymer chains is studied by field-theoretic methods. Special attention is paid to self-avoidance between chain monomers…
Unconcatenated, unknotted polymer rings in the melt are subject to strong interactions with neighboring chains due to the presence of topological constraints. We study this by computer simulation using the bond-fluctuation algorithm for…
We consider a fully directed self-avoiding walk model on a cubic lattice to mimic the conformations of an infinitely long confined flexible polymer chain; and the confinement condition is achieved by two parallel athermal plates. The…
We study the interplay between entropy and topological constraints for a polymer chain in which sliding rings (slip-links) enforce pair contacts between monomers. These slip-links divide a closed ring polymer into a number of sub-loops…
We consider a polymer, with monomer locations modeled by the trajectory of a Markov chain, in the presence of a potential that interacts with the polymer when it visits a particular site 0. Disorder is introduced by, for example, having the…
We investigate polymers pulled away from an interacting surface, where the force is applied to the untethered endpoint and at an angle $\theta$ to the surface. We use the canonical self-avoiding walk model of polymers and obtain the phase…