Related papers: A cm-wave quantum noise limited resonant supercond…
Superconducting microwave amplifiers are essential for sensitive signal readout in superconducting quantum processors. Typically based on Josephson Junctions, these amplifiers require operation at milli-Kelvin temperatures to achieve…
The quest to enhance the sensitivity of electron spin resonance (ESR) is an ongoing challenge. One potential strategy involves increasing the frequency, for instance, moving from Q-band (approximately 35 GHz) to W-band (approximately 94…
The measurement of a quantum system is often performed by encoding its state in a single observable of a light field. The measurement efficiency of this observable can be reduced by loss or excess noise on the way to the detector. Even a…
With a large portfolio of elemental quantum components, superconducting quantum circuits have contributed to dramatic advances in microwave quantum optics. Of these elements, quantum-limited parametric amplifiers have proven to be essential…
A conventional resonant detector is often subject to a trade-off between bandwidth and peak sensitivity that can be traced back to quantum Cramer-Rao Bound. Anomalous dispersion has been shown to improve it by signal amplification and is…
Microwave quantum technologies require amplification of weak signals with minimal added noise at millikelvin temperatures. This stringent demand has been met with superconducting parametric amplifiers. While masers offer another fundamental…
We demonstrate efficient, low power, continuous-wave four-wave mixing in the C-band, using a high index doped silica glass micro ring resonator having a Q-factor of 1.2 million. A record high conversion efficiency for this kind of device is…
We propose a simple yet effective method for low-frequency broadband acoustic absorption. The absorber consists of two concentric space-coiling resonators with distinct resonance frequencies, with the inner resonator characterized by a…
Traveling-Wave Parametric Amplifiers (TWPAs) are ubiquitous in superconducting circuit readout, providing high gain with near-quantum-limited noise performance across a wide bandwidth. Their operation, however, relies on a strong microwave…
The design and experimental demonstration of a large-area, ultra-high-Q-factor and single-mode operation silicon ring resonator based on a strip silicon photonic waveguide are presented, which is suitable for photon gyroscopic application.…
Chip-based optical amplifiers can significantly expand the functionalities of photonic devices. In particular, optical-parametric amplifiers (OPAs), with engineerable gain-spectra, are well-suited for nonlinear-photonic applications.…
This paper develops a theoretical framework for the design of Active Split-Ring Resonators (ASRRs). An ASRR is a Split-Ring Resonator (SRR) equipped with a tunable negative resistor, enabling both switchability and quality factor boosting…
Linear quantum amplifiers are indispensable tools for quantum technologies, yet their performance is fundamentally limited by quantum noise, precluding any signal-to-noise ratio (SNR) enhancement unless supplemented by post-selection or…
Noise at the quantum limit over a large bandwidth is a fundamental requirement for future applications operating at millikelvin temperatures, such as the neutrino mass measurement, the next-generation x-ray observatory, the CMB measurement,…
In analogy to cavity optomechanics, enhancing specific sidebands of a Raman process with narrowband optical resonators would allow for parametric amplification, entanglement of light and molecular vibrations, and reduced transduction noise.…
Micro-ring resonators (MRRs) "trap" incoming light, and therefore, have been shown to achieve extremely high local intensities of light. Thus, they can be used to facilitate highly non-linear optical signals. By embedding materials that…
We have measured the relative permeability of split-ring resonator (SRR) arrays used in metamaterials designed to have $\mu^\prime< 0$ over a narrow range of microwave frequencies. The SRR arrays were loaded into the bore of a loop-gap…
We developed and experimentally tested a Symmetric Traveling Wave Parametric Amplifier (STWPA) based on Three-Wave Mixing, using the new concept of a Symmetric rf- SQUID. This allows to fully control the second and third order…
Phase sensitive amplifiers (PSA), contrary to usual phase insensitive amplifiers (PIA), are in principle capable to achieve noiseless amplification, i.e. exhibit a quantum-limited noise figure (NF) of 0 dB. When implemented using four-wave…
Surface Acoustic Wave (SAW) devices featuring Aluminum Scandium Nitride (AlScN) on a 4H-Silicon Carbide (SiC) substrate, offer a unique blend of high sound velocity, low thermal resistance, substantial piezoelectric response, simplified…