Related papers: A Constrained Formulation for Simultaneous Line Pa…
The impedances of cables and lines used in (multi-conductor) distribution networks are usually unknown or approximated, and may lead to problematic results for any physics-based power system calculation, e.g., (optimal) power flow. Learning…
In this paper we study the question of how to reconstruct the state of a power system using Phasor Measurement Units (PMUs). In our previous research we proved that this question has an affirmative answer imposing some rather strict…
The problem of effective use of Phasor Measurement Units (PMUs) to enhance power systems awareness and security is a topic of key interest. The central question to solve is how to use this new measurements to reconstruct the state of the…
We consider the problem of reconstructing the dynamic state matrix of transmission power grids from time-stamped PMU measurements in the regime of ambient fluctuations. Using a maximum likelihood based approach, we construct a family of…
This study is concerned with the design of a Mueller imaging polarimeter for the visualization of spatially-varying Mueller matrix fields. A simplified calibration procedure is advocated, where all the optical elements are calibrated…
In quantum multiparameter estimation, multiple to-be-estimated parameters are encoded in a quantum dynamics system by a unitary evolution. As the parameters vary, the system may undergo a topological phase transition (TPT). In this paper,…
A tri-objective optimal Micro Phasor Measurement Units ({\mu}-PMUs) Placement method is presented, with a focus on minimizing the following three parameters: i) the total number of {\mu}-PMU channels, (ii) the maximum state estimation…
It is widely recognized that the existing parameter estimators and adaptive controllers for robot manipulators are extremely complicated to be of practical use. This is mainly due to the fact that the existing parameterization includes the…
This paper presents a fast model-agnostic method for recovering noisy Phasor Measurement Unit (PMU) datastreams with missing entries. The measurements are first transformed into a Page matrix, and the original signals are reconstructed…
Inertial measurement units (IMUs) are used in medical applications for many different purposes. However, an IMU's measurement accuracy can degrade over time, entailing re-calibration. In their 2014 paper, Tedaldi et al. presented an IMU…
Phasor measurement units (PMUs) provide accurate and high-fidelity measurements in order to monitor the state of the power grid and support various control and planning tasks. However, PMUs have a high installation cost prohibiting their…
Real-time transient event identification is essential for power system situational awareness and protection. The increased penetration of Phasor Measurement Units (PMUs) enhance power system visualization and real time monitoring and…
Energy meters need to be calibrated for use in Measurement and Verification (M&V) projects. However, calibration can be prohibitively expensive and affect project feasibility negatively. This study presents a novel low-cost in-situ meter…
In modern distribution systems, load uncertainty can be fully captured by micro-PMUs, which can record high-resolution data; however, in practice, micro-PMUs are installed at limited locations in distribution networks due to budgetary…
Today's evolving power system contains an increasing amount of power electronic interfaced energy sources and loads that require a paradigm shift in utility operations. Sub-synchronous oscillations at frequencies around 13-15 Hz, for…
The phasor measurement unit (PMU) placement problem is revisited by taking into account a stronger characterization of the electrical connectedness between various buses in the grid. To facilitate this study, the placement problem is…
Sensors called phasor measurement units (PMUs) are used to monitor the electric power network. The power domination problem seeks to minimize the number of PMUs needed to monitor the network. We extend the power domination problem and…
Recently, multi-sensors fusion has achieved significant progress in the field of automobility to improve navigation and position performance. As the prerequisite of the fusion algorithm, the demand for the extrinsic calibration of…
The estimation of parameters from data is a common problem in many areas of the physical sciences, and frequently used algorithms rely on sets of simulated data which are fit to data. In this article, an analytic solution for…
An online PMU-assisted Power System Parameter Calibration System (PSPCS) was recently developed and implemented at State Grid Jiangsu Electric Power Company (JEPC). PSPCS leverages high-resolution PMU data and data mining techniques to…