Related papers: Room-temperature, continuous wave lasing in planar…
A concept for a low loss all-reflective cavity coupler is experimentally demonstrated at a wavelength of 1064 nm. A 1450 nm period dielectric reflection grating with a diffraction efficiency of 0.58 % in the -1st order is used in 2nd order…
We present a cryogenic microwave noise source with a characteristic impedance of 50 $\Omega$, which can be installed in a coaxial line of a cryostat. The bath temperature of the noise source is continuously variable between 0.1 K and 5 K…
Investigations into the propagation characteristics, specifically loss and wave velocity, of superconducting coplanar waveguides and microstrip lines were conducted at a 2 mm wavelength. This was achieved through the measurement of on-chip…
We demonstrate a technique for obtaining the density of atomic vapor, by doing a fit of the resonant absorption spectrum to a density-matrix model. In order to demonstrate the usefulness of the technique, we apply it to absorption in the…
We report on the room-temperature switching of 1T-TaS2 thin-film charge-density-wave devices, using nanosecond-duration electrical pulsing to construct their time-resolved current-voltage characteristics. The switching action is based upon…
Mesoscopic self-collimation in mesoscopic photonic crystals with high reflectivity is exploited to realize a novel high-Q factor cavity by means of mesoscopic PhC planar mirrors. These mirrors efficiently confine a mode inside a planar…
Reflection at relativistically moving plasma mirrors is a well-known approach for frequency conversion as an alternative to nonlinear techniques. A key issue with plasma mirrors is the need for a high carrier concentration, of order 10^21…
Planar light-emitting diodes (LEDs) fabricated within a single high-mobility quantum well are demonstrated. Our approach leads to a dramatic reduction of radiative lifetime and junction area with respect to conventional vertical LEDs,…
We investigated the effct of pump wavelength on the modal instabilities (MI) in high power linearly-polarized Yb-doped fiber amplifiers. We built a novel semi-analytical model to determine the frequency coupling characteristics and power…
We demonstrate a superconducting (SC) microwave (mw) cavity that can accelerate the dark matter search by maintaining superconductivity in a high DC magnetic field. We used high-temperature superconductor (HTSC) yttrium barium copper oxide…
We demonstrate a 1 GHz prismless femtosecond Ti:sapphire ring laser which emits 890 mW for 7.6W of pump power over a continuum extending from 585 to 1200 nm at -20 dB below the maximum. A broadband continuum is obtained without careful…
For semiconductor device fabrication, Pulsed Laser Annealing (PLA) offers significant advantages over conventional thermal processes. Notably, it can provide ultrafast (~ns) and high temperature profiles ($>1000^\circ$C). When the maximum…
Colloidal semiconductor nanocrystals are promising building blocks for optoelectronics due to their solution processability, spectral tunability, and ability to self-assemble into complex architectures. However, their use in lasing…
Portable mid-infrared (mid-IR) spectroscopy and sensing applications require widely tunable, narrow linewidth, chip-scale, single-mode sources without sacrificing significant output power. However, no such lasers have been demonstrated…
We present an experimental method to determine the refractive index of $Al_{x}Ga_{1-x}As$ (x = 0.0 - 0.5) from 300 K to 4 K across the 500 - 1100 nm wavelength range. The values are extracted from spectroscopically observed microcavity…
The prospects of superradiant lasing on the 7.5 kHz wide $^1$S$_0$-$^3$P$_1$ transition in $^{88}$Sr is explored by using numerical simulations of two systems based on realistic experimental numbers. One system uses the idea of…
Dephasing induced by residual thermal photons in the readout resonator is a leading factor limiting the coherence times of qubits in the circuit QED architecture. This residual thermal population, of the order of $10^{-1}$--$10^{-3}$, is…
A number of the charge-density-wave materials reveal a transition to the macroscopic quantum state around 200 K. We used graphene-like mechanical exfoliation of titanium diselenide crystals to prepare a set of films with different…
We address the scaling-up problem for superconducting quantum circuits by using lumped-element resonators based on an alternative fabrication method of aluminum -- aluminum oxide -- aluminum ($\mathrm{Al/AlO_x/Al}$) parallel-plate…
The interaction of surface acoustic waves (SAW) with $p$-type Si/Si$_{0.87}$Ge$_{0.13}$ heterostructures has been studied for SAW frequencies of 30-300 MHz. For temperatures in the range 0.7$<T<$1.6 K and magnetic fields up to 7 T, the SAW…