Related papers: Optimally Packing a Large Square by Unit Squares

We explore variants of the following open question: Split $[0,1]^2$ into $N^2$ squares with side length $1/N$. Is there a way to select $N$ such squares such that each line intersects only $O(1)$ of them?

In 1967, Moon and Moser proved a tight bound on the critical density of squares in squares: any set of squares with a total area of at most 1/2 can be packed into a unit square, which is tight. The proof requires full knowledge of the set,…

We study three covering problems in the plane. Our original motivation for these problems come from trajectory analysis. The first is to decide whether a given set of line segments can be covered by up to four unit-sized, axis-parallel…

We consider so-called squaring the square-puzzles where a given square (or rectangle) should be dissected into smaller squares. For a specific instance of such problems we demonstrate that a mathematically rigorous solution can be quite…

We provide a tight result for a fundamental problem arising from packing squares into a circular container: The critical density of packing squares into a disk is $\delta=\frac{8}{5\pi}\approx 0.509$. This implies that any set of (not…

In the classic circle packing problem, one asks whether a given set of circles can be packed into a given container. Packing problems like this have been shown to be $\mathsf{NP}$-hard. In this paper, we present new sufficient conditions…

In this paper using the concept of the extended Hamming code we give a construction for dense packing of points at distance at least one in such unit cubes which dimension are a power of two.

Tile the unit square with $n$ small squares. We determine the minimum of the sum of the side lengths of the $n$ small squares, where the minimum is taken over all tilings of the unit square with $n$ squares.

Put n nonoverlapping squares inside the unit square. Let f(n) and g(n) denote the maximum values of the sum of the edge lengths of the n small squares, where in the case of f(n) the maximum is taken over all arbitrary packings of the unit…

We analyze the problem of packing squares in an online fashion: Given a semi-infinite strip of width 1 and an unknown sequence of squares of side length in [0,1] that arrive from above, one at a time. The objective is to pack these items as…

The Sum of Squares algorithm for bin packing was defined in [2] and studied in great detail in [1], where it was proved that its worst case performance ratio is at most 3. In this note, we improve the asymptotic worst case bound to…

Here is a square problem: in a unit square, is there a point with four rational distances to the vertices? A probability argument suggests a negative answer. This paper proves several special cases of the square problem: if the point sits…

It is known that $\sum\limits_{i=1}^{\infty} \frac{1}{i (i+1)} = 1$. In 1968, Meir and Moser asked for finding the smallest $\epsilon$ such that all the rectangles of sizes $1/i \times 1/(i + 1)$ for $i = 1, 2, \ldots$, can be packed into a…

In this paper we have a look at squared squares with small integer sidelengths, where the only restriction is that any two subsquares of the same size are not allowed to share a full border. We prove that there are exactly two such squared…

We prove that one can cover the $1 \times b$ rectangle by equal squares on both sides in one layer iff $b = p \pm \sqrt{p^2 - r^2} $, where $p \ge r \ge 0$ and $p,q \in \mathbb{Q}$.

Consider a set $P$ of $n$ points on the boundary of an axis-aligned square $Q$. We study the boundary-anchored packing problem on $P$ in which the goal is to find a set of interior-disjoint axis-aligned rectangles in $Q$ such that each…

Consider an arrangement of $k$ lines intersecting the unit square. There is some minimum scaling factor so that any placement of a rectangle with aspect ratio $1 \times p$ with $p\geq 1$ must non-transversely intersect some portion of the…

We study dense packings of a large number of congruent non-overlapping circles inside a square by looking for configurations which maximize the packing density, defined as the ratio between the area occupied by the disks and the area of the…

We consider the problem of packing rectangles into bins that are unit squares, where the goal is to minimize the number of bins used. All rectangles have to be packed non-overlapping and orthogonal, i.e., axis-parallel. We present an…

The well-known problem stated by A. Meir and L. Moser consists in tiling the unit square with rectangles (details), whose side lengths equal $1/n\times 1/(n+1)$, where indices~$n$ range from 1 to infinity. Recently, Terence Tao has proved…