Related papers: PCIe400 generic readout board qualification test
We present test results and characterization of a data transmission system based on a last generation FPGA and a commercial QSFP+ (Quad Small Form Pluggable +) module. QSFP+ standard defines a hot-pluggable transceiver available in copper…
The ALICE experiment at the LHC is undergoing a major upgrade during the Long Shutdown 2 (2019-2021). In particular, the Time Projection Chamber (TPC) is being equipped with new GEM-based readout chambers and the readout electronics of…
A new readout technique was developed with the primary aim of keeping the number of channels in the front-end electronics as low as possible when scaling up the sensitive area of a Resistive Plate Chamber (RPC). The readout method here…
The BICEP/Keck Collaboration is currently leading the quest to the highest sensitivity measurements of the polarized CMB anisotropies on degree scale with a series of cryogenic telescopes, of which BICEP Array is the latest Stage-3 upgrade…
We present the design and the test results of a quad-channel optical transceiver module (QTRx) possibly for future particle physics experiments. The transmitters of QTRx, each at 10 Gbps, are based on a Quad-channel VCSEL Diode array Driver…
The upgraded LHCb detector, due to start datataking in 2022, will have to process an average data rate of 4~TB/s in real time. Because LHCb's physics objectives require that the full detector information for every LHC bunch crossing is read…
We present a readout chip prototype for future pixel detectors with timing capabilities. The prototype is intended for characterizing 4D pixel arrays with a pixel size of $100\times100~\mu \text{m}^2$, where the sensors are Low Gain…
The LHCb experiment at CERN has undergone a comprehensive upgrade, including a complete re-design of the trigger system into a hybrid-architecture, software-only system that delivers ten times more interesting signals per unit time than its…
The EVN MkIV data processor is being equipped with a high data output capability, called PCInt. In its next phase it will allow very high data output rates, up to 160 Mb/s. This functionality is required for the high spectral resolution…
The ALICE (A Large Ion Collider Experiment) experiment focuses on the study of the quark-gluon plasma as a product of heavy-ion collisions at the CERN LHC (Large Hadron Collider). During the Long Shutdown 2 of the LHC in 2019-2020, a major…
Charge Coupled Devices (CCDs) have been successfully used in several high energy physics experiments over the past two decades. Their high spatial resolution and thin sensitive layers make them an excellent tool for studying short-lived…
A hybrid readout Time Projection Chamber (TPC) has a simultaneous optical- and charge readout. The optical readout provides 2D images of particle tracks in the active volume, whilst the charge readout provides additional information on the…
A fast-reading current integrator is developed for high time-resolution and low-noise ion beam diagnostics under both continuous-wave and pulsed operating conditions. The system combines a low-leakage transimpedance front-end with a hybrid…
The Large High Altitude Air Shower Observatory is in the R&D phase, in which the Water Cherenkov Detector Array is an important part. The signals of Photo-Multiplier Tubes would vary from single photo electron to 4000 photo electrons, and…
This work presents the design and preliminary performance of a highly-multiplexed superconducting detector readout. The readout system is implemented on the Xilinx ZCU111 RFSoC Evaluation Board. The current design uses 12% of the DSPs, 60%…
In this paper, we present the design and realization of high bandwidth pickup electrodes with a cutoff frequency above 40 GHz. The proposed cone-shaped pickups are part of a bunch arrival-time monitor (BAM) designed for high (> 500 pC) and…
Motivated by the stringent requirements of the Upstream Pixel (UP) tracker in the LHCb Upgrade II and the Inner Tracking detector (ITK) of the Circular Electron Positron Collider, the COFFEE series of pixel sensor chips have been developed…
The CALICE collaboration is currently developing an engineering prototype of an analog hadron calorimeter for a future linear collider like the ILC. One main task of this prototype is to demonstrate the feasibility of building a realistic…
A new tracking detector will be installed as part of the Phase-2 upgrade of the CMS detector for the high-luminosity LHC era. This tracking detector includes the Inner Tracker, equipped with silicon pixel sensor modules, and the Outer…
In 2019, the LHCb experiment at CERN will undergo a major upgrade where its detector electronics and the entire readout system will be replaced. The goal is to read-out all events at the full LHC frequency of 40 MHz, reaching a total data…