Related papers: PCIe400 generic readout board qualification test
Achieving maximum possible rate of inferencing with minimum hardware resources plays a major role in reducing enterprise operational costs. In this paper we explore use of PCIe streaming on FPGA based platforms to achieve high throughput.…
This paper presents a novel IP design for real-time fault/error detection and recovery on a peripheral component interconnect express (PCIe) which interfaces a host system (here a PC) to a slave design including processing system and memory…
The performance of discrete general purpose graphics processing units (GPGPUs) has been improving at a rapid pace. The PCIe interconnect that controls the communication of data between the system host memory and the GPU has not improved as…
High-throughput physics experiments require efficient and increasingly complex real-time processing. This paper presents a modular, software-defined platform combining high-bandwidth PCIe digitizers with consumer GPUs to achieve continuous,…
We propose without loss of generality strategies to achieve a high-throughput FPGA-based architecture for a QC-LDPC code based on a circulant-1 identity matrix construction. We present a novel representation of the parity-check matrix (PCM)…
We have developed a cryogenic platform for the control and readout of spin qubits that comprises a high density of dc and radio frequency sample interconnects based on a set of coupled printed circuit boards. The modular setup incorporates…
The Compressed Baryonic Matter (CBM) experiment will investigate the quantum chromodynamics (QCD) phase diagram at high net baryon densities and moderate temperatures. CBM Time of Flight (TOF) system is composed of super modules containing…
State of the art detector readout electronics require high-throughput data acquisition (DAQ) systems. In many applications, e. g. for medical imaging, the front-end electronics are set up as separate modules in a distributed DAQ. A…
In view of the High Luminosity LHC, the current CMS tracking detector will have to be replaced during Long Shutdown 3 to cope with the higher radiation environment and to withstand an increased data rate. To prepare for the so-called CMS…
For LHC Run 3, the ALICE Time Projection Chamber was upgraded to operate in continuous readout mode. Interaction rates of up to 50 kHz in Pb-Pb collisions require real-time processing of more than 3 TB/s of raw detector data. This…
The GOSIP (Gigabit Optical Serial Interface Protocol) provides communication via optical fibres between multiple kinds of front-end electronics and the KINPEX PCIe receiver board located in the readout host PC. In recent years a stack of…
A new TDC-chip is under development for the COMPASS experiment at CERN. The ASIC, which exploits the 0.6 micrometer CMOS sea-of-gate technology, will allow high resolution time measurements with digitization of 75 ps, and an unprecedented…
With the increasing physical event rate and number of electronic channels, traditional readout scheme meets the challenge of improving readout speed caused by the limited bandwidth of crate backplane. In this paper, a high-speed data…
Since the 1990s, there has been a dramatic interest in quantum communication. Free-space quantum communication is being developed to ultra-long distance quantum experiment, which requires higher electronics performance, such as time…
Bridge++ is a general-purpose code set for a numerical simulation of lattice QCD aiming at a readable, extensible, and portable code while keeping practically high performance. The previous version of Bridge++ is implemented in double…
With the rapid development of network protocol, TCP/IP has been widely applied in various OS systems because of its advantages of high-speed network transmission and standardization. Furthermore, TCP/IP has the functions of retransmission…
We developed a PCI interface for GRAPE systems. GRAPE(GRAvity piPE) is a special-purpose computer for gravitational N-body simulations. A GRAPE system consists of GRAPE processor boards and a host computer. GRAPE processors perform the…
Due to the increased demand of network traffic expected during the HL-LHC era, the T2 sites in the USA will be required to have 400Gbps of available bandwidth to their storage solution. With the above in mind we are pursuing a scale test of…
The ALICE experiment will run with continuous readout at interaction rates of up to 50 kHz in Pb-Pb collisions during Run 3 of the LHC. In order to achieve this goal, a new data processing scheme and software are developed. This scheme…
The detector readout architecture introduced in this paper is intended for small to medium size physics experiments that have moderate bandwidth needs, and applications that require an ultimately low background radioactivity for the parts…