Related papers: Detection of high-frequency gravitational waves us…
Here we propose a new gravitational waves(GWs) detector in broad frequency band, which is operated at exceptional points(EPs) in micro cavities. The detected signal is an eigenfrequency split of the mechanical modes caused by the spatial…
Frequency response function (FRF) measurements are widely used in Gravitational Wave (GW) detectors, e.g., for the design of controllers, calibrating signals and diagnostic problems with system dynamics. The aim of this paper is to present…
We exploit forecast sensitivities to high frequency gravitational waves (HFGWs) from superconducting LC circuits, traditional resonant cavity and superconducting radio frequency (SRF) cavities with electromagnetic and mechanical modes to…
Direct detection of gravitational radiation in the audio band is being pursued with a network of kilometer-scale interferometers (LIGO, Virgo, KAGRA). Several space missions (LISA, DECIGO, BBO) have been proposed to search for sub-Hz…
The higher efficiency of superconducting radio-frequency (SRF) cavities compared to normal-conducting ones enables the development of high-energy continuous-wave linear accelerators (linacs). Recent progress in the development of…
Recent developments in superconducting radio-frequency (SRF) research have focused primarily on high frequency elliptical cavities for electron accelerators. Advances have been made in both reducing RF surface resistance and pushing the…
We present the results of a LIGO search for short-duration gravitational waves (GW) associated with soft gamma repeater (SGR) bursts. This is the first GW search sensitive to neutron star f-modes, usually considered the most efficient GW…
We propose a new method for detecting high-frequency gravitational waves (GWs) using high-energy pulsed lasers. Through the inverse Gertsenshtein effect, the interaction between a GW and the laser beam results in the creation of an…
After first reviewing the gravitational wave (GW) spectral classification. we discuss the sensitivities of GW detection in space aimed at low frequency band (100 nHz-100 mHz) and middle frequency band (100 mHz-10 Hz). The science goals are…
GEO 600, Kagra, LIGO, and Virgo were built to observe gravitational waves at frequencies in the audio band, where the highest event rates combined with the largest signal to noise ratios had been predicted. Currently, hypothetical sources…
We propose Fast Radio Burst (FRB) timing, which uses the precision measurements of the arrival time differences of repeated FRB signals along multiple sightlines, as a new probe of gravitational waves (GWs) around nHz to $\mu$Hz…
Gravitational wave (GW) detection in space is aimed at low frequency band (100 nHz - 100 mHz) and middle frequency band (100 mHz - 10 Hz). The science goals are the detection of GWs from (i) Supermassive Black Holes; (ii) Extreme-Mass-Ratio…
Gravitational Waves (GWs) from the early universe and unresolved astrophysical sources are expected to create a stochastic GW background (SGWB). The GW radiometer algorithm is well suited to probe such a background using data from ground…
The DECi hertz Interferometer Gravitational-Wave Observatory (DECIGO) is a space gravitational wave (GW) detector. DECIGO was originally designed to be sensitive enough to observe primordial GW background (PGW). However, due to the lowered…
A localized measurement of the RF critical field on superconducting radio frequency (SRF) cavity materials is a key step to identify specific defects that produce quenches of SRF cavities. Two new measurements are performed to demonstrate…
We present an approach to experimentally evaluate gravity gradient noise, a potentially limiting noise source in advanced interferometric gravitational wave (GW) detectors. In addition, the method can be used to provide sub-percent…
A new detector, the Fermilab Holometer, consists of separate yet identical 39-meter Michelson interferometers. Strain sensitivity achieved is better than $10^{-21} /{\sqrt{\rm{Hz}}}$ between 1 to 13 MHz from a 130-hr dataset. This…
Achieving the demanding sensitivity and bandwidth, envisaged for third generation gravitational wave (GW) observatories, is extremely challenging with a single broadband interferometer. Very high optical powers (Megawatts) are required to…
We propose two distinct atom interferometer gravitational wave detectors, one terrestrial and another satellite-based, utilizing the core technology of the Stanford $10 \text{m}$ atom interferometer presently under construction. The…
We show that the Laser Interferometer Gravitational Wave Observatory (LIGO) is a powerful instrument in the Search for Extraterrestrial Intelligence (SETI). LIGO's ability to detect gravitational waves (GWs) from astrophysical sources, such…