Related papers: PAPR Analysis for MIMO FTN Signaling with Gaussian…
Faster-than-Nyquist (FTN) signaling is a non-orthogonal transmission technique offering a promising solution for future generations of communications. This paper studies the capacity of FTN signaling in multiple-input multiple-output (MIMO)…
Peak to average power ratio (PAPR) constrained power allocation in single carrier multiuser (MU) single-input multiple-output (SIMO) systems with iterative frequency domain (FD) soft cancelation (SC) minimum mean squared error (MMSE)…
One of the fundamental endeavors in radio frequency (RF) metrology is to measure the power of signals, where a common aim is to estimate the peak-to-average power ratio (PAPR), which quantifies the ratio of the maximum (peak) to the mean…
We consider the problem of peak-to-average power ratio (PAPR) reduction in orthogonal frequency-division multiplexing (OFDM) based massive multiple-input multiple-output (MIMO) downlink systems. Specifically, given a set of symbol vectors…
The capacity and optimal signaling over a fixed Gaussian MIMO channel are considered under the joint total and per-antenna power constraints (TPC and PAC). While the general case remains an open problem, a closed-form full-rank solution is…
This paper focuses on the performance analysis of a class of limited peak-to-average power ratio (PAPR) precoders for downlink multi-user massive multiple-input multiple-output (MIMO) systems. Contrary to conventional precoding approaches…
High peak-to-average power ratio (PAPR) is one of the main factors limiting cell coverage for cellular systems, especially in the uplink direction. Discrete Fourier transform spread orthogonal frequency-domain multiplexing (DFT-s-OFDM) with…
Massive MIMO systems are typically designed assuming linear power amplifiers (PAs). However, PAs are most energy efficient close to saturation, where non-linear distortion arises. For conventional precoders, this distortion can coherently…
We consider the problem of peak-to-average power ratio (PAPR) reduction for orthogonal frequency-division multiplexing (OFDM) based large-scale multiple-input multipleoutput (MIMO) systems. A novel perturbation-assisted scheme is developed…
Consider a problem of forward error-correction for the additive white Gaussian noise (AWGN) channel. For finite blocklength codes the backoff from the channel capacity is inversely proportional to the square root of the blocklength. In this…
Meeting the challenges of 5G demands better exploitation of the available spectrum by allowing multiple parties to share resources. For instance, a secondary unlicensed system can share resources with the cellular uplink of a primary…
In this paper, we consider communication over the bandwidth limited analog white Gaussian noise channel using non-orthogonal pulses. In particular, we consider non-orthogonal transmission by signaling samples at a rate higher than the…
The peak power problem in multicarrier waveforms is well-known and imposes substantial limitations on wireless communications. As the quest for investigation of enabling technologies for the next generation of wireless communication systems…
In this paper, we show bounds on Peak-to-Average Power Ratio (PAPR) and propose a method to reduce PAPR. These bounds are written in terms of moments of transmitted symbols. Further, we show some bounds in special cases and these special…
This paper analyzes faster-than-Nyquist (FTN) signaling within a consistent framework based on a fixed time-bandwidth product (TBP), resolving potential ambiguities present in finite blocklength analysis. A key feature of FTN is its ability…
We consider the problem of peak-to-average power ratio (PAPR) reduction in orthogonal frequency division multiplexing (OFDM) systems via optimized sparsification of tone reservation (TR). In particular, we propose a novel TR optimization…
Low peak-to-average power ratio (PAPR) transmission is an important and favorable requirement prevalent in radar and communication systems, especially in transmission links integrated with high power amplifiers. Meanwhile, motivated by the…
Simultaneous wireless information and power transfer (SWIPT) critically depends on waveform design, which governs both reliable data delivery and efficient energy harvesting. Among waveform characteristics, the peak-to-average power ratio…
The sub-THz spectrum offers numerous advantages, including massive multiple-input multiple-output (MIMO) technology with large antenna arrays that enhance spectral efficiency (SE) of future systems. Hybrid precoding (HP) thus emerges as a…
OFDM signals demonstrates high fluctuations termed as Peak to Average Power Ratio (PAPR).The problem of OFDM is the frequent occurrence of high Peaks in the time domain signal which in turn reduces the efficiency of transmit high power…