Related papers: High-throughput controlled droplets generation thr…
We study the stationary and transient behaviors of the microemulsion phase subjected to a shear flow. The system is described by a diffusion-convective equation which generalizes the usual Cahn-Hilliard equation. Non-linear terms are…
The dynamics of microcapsules in steady shear flow was studied using a theoretical approach based on three variables: The Taylor deformation parameter $\alpha_{\rm D}$, the inclination angle $\theta$, and the phase angle $\phi$ of the…
An electrohydrodynamic numerical model is used to explore the electrospray emission behavior of both moderate and high electrical conductivity liquids under electrospray conditions. The Volume-of-Fluid method, incorporating a…
Ternary interactions between hetero-fluid particles, particularly the dynamics of droplets spreading over curved fluid interfaces remain insufficiently understood compared to the two-phase coalescence. In this study, we combine lattice…
We present a mesoscale representation of near-contact interactions between colliding droplets which permits to reach up to the scale of full microfluidic devices, where such droplets are produced. The method is demonstrated for the case of…
A nonlocal interface equation is derived for two-phase fluid flow, with arbitrary wettability and viscosity contrast c=(mu_1-mu_2)/(mu_1+mu_2), in a model porous medium defined as a Hele-Shaw cell with random gap b_0+delta b. Fluctuations…
A computational framework is developed to address capillary self-focusing in Step Emulsification. The microfluidic system consists of a single shallow and wide microchannel that merges into a deep reservoir. A continuum approach coupled…
Based on mesoscale lattice Boltzmann simulations with the "Shan-Chen" model, we explore the influence of thermocapillarity on the break-up properties of fluid threads in a microfluidic T-junction, where a dispersed phase is injected…
Droplet deposition onto a hydrophobic surface is studied experimentally and numerically. A wide range of droplet sizes can result from the same syringe, depending strongly on the needle retraction speed. Three regimes are identified…
We present a mesoscale kinetic model for multicomponent flows, augmented with a short range forcing term, aimed at describing the combined effect of surface tension and near-contact interactions operating at the fluid interface level. Such…
The deformation and breakup of droplets in airflows is important in spray and atomisation processes, but the shear effect in non-uniform airflow is rarely reported. In this study, the deformation and breakup of droplets in a shear flow of…
Micro droplets are extensively used in chemical, biological, and medical research, primarily for conducting various tests on samples, including living organisms, using a microfluidic framework. Recent studies have shown that the physiology…
We propose an extension of the phenomenological Maffettone-Minale (MM) model (P.L. Maffettone and M. Minale, J. Non-Newton. Fluid Mech. 78, 227-241 (1998)) to describe the time-dependent deformation of a droplet with interfacial viscosity…
We used volume-of-fluid (VOF) method to perform three-dimensional numerical simulations of droplet formation of Newtonian fluids in microfluidic T-junction devices. To evaluate the performance of the VOF method we examined the regimes of…
Results from Monte Carlo simulations of wall-attached droplets in the three-dimensional Ising lattice gas model and in a symmetric binary Lennard-Jones fluid, confined by antisymmetric walls, are analyzed, with the aim to estimate the…
In this paper we present a comprehensive study of the step-emulsification process for high-throughput production of (sub-)$\mu$m-size monodisperse droplets. The microfluidic device combines a Hele-Shaw nanofluidic cell with a step-like…
The evaporation of multi-component droplets is relevant to various applications but challenging to study due to the complex physicochemical dynamics. Recently, Li (2018) reported evaporation-triggered segregation in 1,2-hexanediol-water…
Collision of two dispersed drops in the matrix of suspending liquid is the first step toward coalescence. However, to quantify the rate of coalescence, the configuration of the collision should be definable and the force that induces the…
High speed microfluidic jets can be generated by a thermocavitation process: from the evaporation of the liquid inside a microfluidic channel, a rapidly expanding bubble is formed and generates a jet through a flow focusing effect. Here, we…
Solvent shifting is a process in which a non-solvent is added to a solvent/solute mixture and extracts the solvent. The solvent and the non-solvent are miscible. Because of solution supersaturation a portion of the solute transforms to…